Acid-base titrations in solvents of relatively low dielectric constant
نویسندگان
چکیده
منابع مشابه
A fully automatic system for acid-base coulometric titrations
An automatic system for acid-base titrations by electrogeneration of H(+) and OH(-) ions, with potentiometric end-point detection, was developed. The system includes a PC-compatible computer for instrumental control, data acquisition and processing, which allows up to 13 samples to be analysed sequentially with no human intervention.The system performance was tested on the titration of standard...
متن کاملA Dipstick Sensor for Coulometric Acid-base Titrations
By performing an acid-base titration by coulometric generation of OHor H+ ions at an inert electrode in close proximity to the pH-sensitive gate of an ISFET, it is possible to determine the acid or base concentration of a solution using the ISFET as an indicator device for the equivalence point in the titration curve. Typical values for the titration time are 0.1 to 10 s for acid or base concen...
متن کاملELECTRICAL CONDUCTIVITY OF LOW DIELECTRIC CONSTANT LIQUIDS by
This experimental investigation was carried out in order to determine the electrical characteristics of several hydrocarbons of low dielectric constant. All measurements of the conduc ivity were below 1 picomho/m (u.10A/V-m 10-14 ohm'lcml). This category ncludes most petroleum products, petroleum distillates made conductive by adding anti-static additives, and liquified gases. Of particular int...
متن کاملComplexity in Acid–Base Titrations: Multimer Formation Between Phosphoric Acids and Imines
Solutions of Brønsted acids with bases in aprotic solvents are not only common model systems to study the fundamentals of proton transfer pathways but are also highly relevant to Brønsted acid catalysis. Despite their importance the light nature of the proton makes characterization of acid-base aggregates challenging. Here, we track such acid-base interactions over a broad range of relative com...
متن کاملDetermination of Dielectric Constant
Introduction The dielectric constant of PCB material is important in determining the trace width required to produce a characteristic impedance of 50 ohms, or any other desired impedance. The most commonly used material, FR-4, has a dielectric constant that may vary widely between manufacturers or batches, and also varies over frequency. It is useful to have a method to determine the dielectric...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Analytica Chimica Acta
سال: 1973
ISSN: 0003-2670
DOI: 10.1016/s0003-2670(01)82358-8