Accelerated Fatigue Crack Growth in 6082 T651 Aluminium Alloy Subjected to Periodic Underloads
نویسندگان
چکیده
منابع مشابه
Accelerated Threshold Fatigue Crack Growth Effect – Powder Metallurgy Aluminum Alloy
Fatigue crack growth (FCG) research conducted in the near threshold regime has identified a room temperature creep crack growth damage mechanism for a fine grain powder metallurgy (PM) aluminum alloy (8009). At very low ∆K, an abrupt acceleration in room temperature FCG rate occurs at high stress ratio (R = Kmin/Kmax). The near threshold accelerated FCG rates are exacerbated by increased levels...
متن کاملFatigue crack growth in a coarse-grained iron–silicon alloy
The fatigue crack growth in a coarse-grained Fe-2 wt% Si alloy is investigated in considerable detail. At room temperature, the material is quasi-brittle and the failure mode is mixed cleavage. Under a mode-I cyclic loading, the crack can overcome the barrier effect of grain boundaries, which dominates the overall damage evolution. Associated with the geometrically necessary crack front branchi...
متن کاملEnhanced Exponential Fatigue Crack Growth Model for Al-alloy
In the present investigation, an attempt has been made to use “exponential model” in the prediction of fatigue life without integrating the fatigue crack growth rate curve (FCGR). The obtained results are compared with experimental crack growth data obtained for 2024-T351 aluminum alloy for four bending V-Charpy specimens under constant amplitude loading in stress ratio range from 0.1 to 0.3 an...
متن کاملX-ray analysis of polycrystalline aluminium subjected to fatigue cycling
Variations in the halfwidth values of X-ray reflections from fatigue-cycled, polycrystalline aluminium samples have been analysed. An oscillatory variation of the halfwidths with fatigue cycling has been observed. Analysis of the diffraction line profiles indicates that broadening arises mainly because of the build-up of microstrains during fatigue cycling. The present data indicate that (i) br...
متن کاملModelling Crack Propagation in Aluminium-Alloys 2524-T3 and 7050-T7452 Subjected to Fatigue Loading at Low Temperature
Modelling Crack Propagation in Aluminium-Alloys 2524-T3 and 7050-T7452 Subjected to Fatigue Loading at Low Temperature M. D. Liu and J. J. Xiong * School of Transportation Science and Engineering, Beihang University, Beijing 100191, China; [email protected] * Correspondence: [email protected] Abstract: This paper seeks to model the crack propagation in of AAs (aluminum-alloys) 2524-T3 and 705...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2013
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2013.12.086