AC loss in extruded polyethylene insulated superconduciting power cable.
نویسندگان
چکیده
منابع مشابه
Long-life Xlpe Insulated Power Cable
Crosslinked polyethylene (XLPE) has become the globally preferred insulation for power cables, both for distribution and transmission system applications. This insulation system provides cost efficiency in operation and procurement, as well as lower environmental and maintenance requirements when compared to older impregnated paper systems. The purpose of this paper is to outline some of the de...
متن کاملSimulation of AC Loss in High Temperature Superconducting Cable using COMSOL Multiphysics
In this paper simulation of the alternating current loss (AC loss) in a high temperature superconducting tape and a HTS cable having 4 layers of polygon conductors using COMSOL Multiphysics software has been reported. The simulation results for the single rectangular tape are verified with the Norris equation for a HTS tape. The effect of increased number of layers on AC loss is also observed u...
متن کاملتخمین عمر عایقی کابل های فشار قوی XLPE تحت تنش های حرارتی، الکتریکی و همزمان
The aging of insulating materials can be estimated by an electrical breakdown occurring in electrical components so that the relationship between lifetime, failure probability and reliability of electrical components may be studied using the life models in high voltage cables networks. In last decades with attention to higher features as electrical, thermal, mechanical characteristic, widely cr...
متن کاملPower in AC Circuits
Complex power is discussed in Sections 11.5 and 11.6 of Introduction to Electric Circuits by R.C. Dorf and J.A Svoboda. In particular, Table 11.5-1 summarizes the equations used to calculate complex power in the frequency domain. Circuit analysis in the frequency-domain is described in Sections 10.6 thru 10.11. Table 10.7-1 summarizes the correspondence between the time domain and the frequency...
متن کاملReturn to Session THE USE OF INSULATED WIRES MILLIKEN CONDUCTORS IN HIGH VOLTAGE POWER TRANSMISSION UNDERGROUND AC LINES
These last years have pointed out a significant increase of the power that needs to be transported by underground power cables. As a consequence, large cross section conductors, up to 2500mm2 are now customarily used. The CIGRE group B1-03 has completed in 2005 a work that analyses the actual AC resistance of these large cross section conductors as a function of their design. The authors discus...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TEION KOGAKU (Journal of Cryogenics and Superconductivity Society of Japan)
سال: 1989
ISSN: 0389-2441,1880-0408
DOI: 10.2221/jcsj.24.338