Absolute viscosity of water at 20-degrees-C
نویسندگان
چکیده
منابع مشابه
Viscosity of interfacial water.
The effective shear viscosity and frequency-dependent dynamic oscillatory shear spectra of water containing monovalent or divalent ions (ionic strength 25 mM), confined between mica crystals at 1-2 water molecules thickness, oscillated with twist angle with the period expected for the pseudohexagonal surface lattice. The effective viscosity varied by orders of magnitude as the twist angle was c...
متن کاملProperties of single cardiac Na channels at 35 degrees C
Single Na channel currents were recorded in cell-attached patches of mouse ventricular myocytes with an improved patch clamp technique. Using patch pipettes with a pore diameter in the range of 200 nm, seals with a resistance of up to 4 T omega were obtained. Under those conditions, total noise could be reduced to levels as low as 0.590 pA rms at 20 kHz band width. At this band width, propertie...
متن کاملEffects of a novel ice-cooling technique on work in protective clothing at 28 degrees C, 23 degrees C, and 18 degrees C WBGTs.
This study tested a new ice cooling system that permits ice cooling system recharge without personal protective clothing removal. Six male volunteers (22.1 +/- 1.2 years) underwent tests with the new ice cooling system (COOL) and without (NOCL) at a moderate work rate (450 W) in three environments of 28, 23, and 18 +/- 1 degrees C wet bulb globe temperature. Walks at 28 degrees C were carried o...
متن کاملKinetics of oxygen consumption after a single isometric tetanus of frog sartorius muscle at 20 degrees C
The time-course of the rate of oxygen consumption (QO2) has been measured in the excised frog sartorius muscle after single isometric tetani of 0.1-1.0 s at 20 degrees C. To measure deltaQO2(t), the change in QO2 from its basal level, a novel method was devised, based on the validity in this tissue of the one-dimensional diffusion equation for oxygen, established in the preceding paper. After a...
متن کاملFreeze-fracturing in ultrahigh vacuum at -196 degrees C
Conventional freeze-etching is carried out in a vacuum of approximately 10(-6) torr and at a specimen temperature of -100 degrees C. The relatively poor topographic resolution of most freeze-etch replicas, and the lack of complementarity of morphological details in double replicas have been thought to be caused by structural distortions during fracturing, and radiation damage during replication...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Research of the National Bureau of Standards
سال: 1952
ISSN: 0091-0635
DOI: 10.6028/jres.048.001