Abrasive Wear Behaviour of Organophosphate

Effect of Abrasive Size on Wear

Modelling Friction and Abrasive Wear of Elastomers

In order to properly model the friction and wear of elastomer materials, it is essential to understand some specific mechanical and tribological features. Mechanical characteristics of elastomer materials are different from those of metals and other relatively hard materials. Elastomers can bear large deformations, the stress-strain curves are non-linear, time and temperature dependent. When th...

AN INVESTIGATION ON ABRASIVE WEAR BEHAVIOUR OF Fe-C-Mo-FeCr COMPOSITE PRODUCED BY POWDER METALLURGY

In this study, the effect of chromium carbide (Cr7C3) on abrasive wear behavior of Fe-C-Mo-FeCr composite was investigated. Composite, which was produced by a powder metallurgy route was containing 3 wt.% Mo, 1.5 wt. % C and 4,8,12 wt. % FeCr with the different particle sizes. In the experiments, wear resistance of samples were determined using different loads by a pin on disc wear tester. Micr...

Two-body and three-body abrasive wear behaviour of polyaryletherketone composites

Single and multipass two-body and three-body abrasive wear behaviour of various polyaryletherketone composites have been carried out by using a pin-on-disc machine and a rubber wheel abrasion test (RWAT) rig. Abrasive wear studies were conducted under different loads and sliding distances. Comparative wear performance of all the composites at different loads shows that specific wear rate (Ko) o...

Effect of Abrasive Particle Size on Abrasive Wear Resistance in Otomotive Steels

If one of the surfaces which are in touch is rough and hard, it chips the other surface due to relative motion or touching forces. The wear is called two-body abrasive wear. If there are free abrasive particles between the two bodies, the wear is called three-body abrasive wear. The free abrasive particles may be external material dust or the remains of chipping. Usually, the wear starts as a t...