A versatile fast low noise preamplifier in UHF bipolar technology
نویسندگان
چکیده
منابع مشابه
Low-power Adaptive Bipolar Low Noise Amplifier
In this paper, a low-power adaptive low noise amplifier (LNA) is presented. The LNA is based on a bipolar cascode topology, uses inductive source degeneration and emitter area scaling to achieve noise and input-impedance matching simultaneously. The input impedance and the noise factor were simulated as function of the bias collector current and the results show that both are approximately cons...
متن کاملLow-noise preamplifier with input and feedback transformers for low source resistance sensors
We describe the design, schematics, and performances of a very-low-noise, low-frequency preamplifier. It operates in the 5 Hz-100 kHz range and offers an input equivalent voltage noise density as low as 65 pV/ ,/I%; the current noise increases with frequency and settles to about 1.5 pA/ @ at 100 kHz. The amplifier uses input and feedback signal transformers and operates in full differential mod...
متن کاملIrradiation tests on bipolar front-end preamplifier using the Harris UHF1 technology
A low noise, low power, radiation hard, full custom integrated circuit has been studied for coupling with photodetectors of the CMS electromagnetic calorimeter. A new version of the prototype preamplifier has been designed with improved performances (noise, dynamic range, consumption). Irradiation tests on this monolithic circuit have been performed at CERN with a Xray SEIFERT RP149 generator u...
متن کاملA Low-Noise, Wideband CMOS Charge Sensitive Preamplifier for the High Precision Pixel Detector
A 0.18μm CMOS low-noise wideband charge sensitive preamplifier (CSP) used in a high precision pixel detector was presented in this paper. The preamplifier consists of charge amplification and constant current feedback circuit to accumulate the input charge signal in the feedback capacitor and discharge it by constant current. The open-loop gain of the preamplifier is 52dB at DC, and -3dB bandwi...
متن کاملDesign of a Low-Noise Preamplifier for Nerve Cuff Electrode Recording
This paper discusses certain important issues involved in the design of a nerve signal preamplifier for implantable neuroprostheses. Since the electroneurogram signal measured from cuff electrodes is typically on the order of 1 V, a very low-noise interface is essential. We present the argument for the use of BiCMOS technology in this application and then describe the design and evaluation of a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
سال: 2000
ISSN: 0168-9002
DOI: 10.1016/s0168-9002(99)01254-1