A Uniform Pressure Electromagnetic Actuator for Forming Flat Sheets
نویسندگان
چکیده
منابع مشابه
A New Electromagnetic Valve Actuator
In conventional internal combustion (IC) engines, engine valve displacements are fixed relative to crankshaft position. If these valves are actuated as a variable function of crankshaft angle, significant improvements in fuel economy can be achieved. Existing electromagnetically actuated variable-valve-timing (VVT) systems characteristically use springs to provide the large inertial power to mo...
متن کاملActuator fault diagnosis for flat systems: A constraint satisfaction approach
This paper describes a robust set-membership-based Fault Detection and Isolation (FDI) technique for a particular class of nonlinear systems, the so-called flat systems. The proposed strategy consists in checking if the expected input value belongs to an estimated feasible set computed using the system model and the derivatives of the measured output vector. The output derivatives are computed ...
متن کاملIdentification of an Electromagnetic Actuator
We apply time-domain system identification techniques to an electromagnetic actuator. This actuator is part of the vibration isolation testbed at the University of Michigan.
متن کاملTape Mechanics over a Flat Recording Head under Uniform Pull-down Pressure
The mechanics of the "tape" over a flat-head is investigated. It has been recently shown that a thin, flexible tape, traveling over a flat recording head under tension contacts the head over the central area of the head. This phenomenon is due to the selfacting, subambient foil bearing effect. In this paper, as a first order of approximation, a simplified system is analyzed; where a uniform sub...
متن کاملFlexible Forming of Thin Aluminum Alloy Sheets
Flexible forming is a sheet metal forming process with the application of soft material tooling. In this study, flexible (silicone rubber, SR, and styrene butadiene rubber, SBR) and semi-rigid (polyamide 66, PA) polymeric materials were adopted to make several upper dies which were used in combination with aluminium lower dies. Stamping operations were performed on a thin aluminium alloy sheet ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Manufacturing Science and Engineering
سال: 2006
ISSN: 1087-1357,1528-8935
DOI: 10.1115/1.2515481