A Tungsten Base Hard Alloy Dispersion Strengthend with TiB2.
نویسندگان
چکیده
منابع مشابه
Grain Boundary Mobility in Fe-Base Oxide Dispersion Strengthened PM2000 Alloy
An alloy can be created without melting, by violently deforming mixtures of different powders. As first discovered by Benjamin, inert oxides can also be introduced into the microstructure using this technique. The resulting dispersion-strengthened alloyed powders are then consolidated using hot-isostatic pressing and extrusion, to produce a solid with a very fine grain structure on a sub-microm...
متن کاملSURFACE HARDENING OF TUNGSTEN-BASED HEAVY ALLOY VIA PACK BORONIZING
The boronizing of a tungsten heavy alloy containing Ni and Fe as the major alloying elements were performed in the present study to increase its surface hardening. Pack cementation method was employed as a well-known, successful solid-state process for boronizing. The coating treatment was accomplished at different temperatures of 1000, 1050 and 1100°C for 6 and 9 hours. The formation of tu...
متن کاملDEVELOPMENT OF A TUNGSTEN HEAVY ALLOY, W-Ni-Mn, USED AS KINETIC ENERGY PENETRATOR
Abstract: The objective of this research was to develop a tungsten heavy alloy (WHA) having a microstructure and properties good enough to penetrate hard rolled steels as deep as possible. In addition this alloy should not have environmental problems as depleted uranium (DU) materials. For this purpose a wide spread literature survey was performed and on the base of information obtained in ...
متن کاملRefining Mechanism of 7075 Al Alloy by In-Situ TiB2 Particles
The nucleation undercooling of TiB₂/7075 Al matrix composites, the microstructure observed after solidification at different cooling rate, and the size and distribution of TiB₂ particles were investigated. The experimental results have shown that the grain sizes of TiB₂/7075 Al matrix composites firstly decreased, then increased, and finally decreased again with the increase of TiB₂ content. Th...
متن کاملMicrostructural Evolution of Copper-Titanium Alloy during In-situ Formation of TiB2 Particles
Bulk Cu-Ti alloy reinforced by TiB2 nano particles was prepared using in-situ reaction between Cu3.4wt.% Ti and Cu-0.7wt.% B along with rapid solidification and subsequent heat treatment for 1-10 hrs at 900oC. High-resolution transmission electron microscopy (HRTEM) characterization showed that primary TiB2 nano particles and TiB whiskers were formed by in-situ reaction between Ti and B in the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1993
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.40.72