A Study on the Molding Characteristics of Injection Compression Molding Through Computer Simulation
نویسندگان
چکیده
منابع مشابه
A Study on Computer Simulation of Plastic Lens Molding Process
In this paper, some molding process parameters such as injection time, packing time, packing pressure and process temperature etc. were optimized by the Computer Aided Engineering (CAE) simulation (Moldex 3D) for injection molding of a plastic lens. Some experimental trials were carried out for verifying of the CAE simulation results with checking of the lens shrinkage and birefringence etc. as...
متن کاملLIMS - Liquid Injection Molding Simulation
design and analysis software solutions for composite structures for more than two decades. The software is continuously upgraded to reflect new research findings as well as to capitalize on advances in computing technology. Software applications such as CDS2.0, LIMS and MAT162 are used extensively by researchers at UD-CCM and industrial sponsors to predict material properties and behavior durin...
متن کاملPrecision Injection Molding PRECISION PROCESS CONTROL OF INJECTION MOLDING
1 INTRODUCTION The technical requirements of precision injection molded components demand a heightened level of process performance, and with corresponding process monitoring and control technologies. To obtain the desired critical to quality attributes (CTQs) of the molded products, the injection molding process must be consciously designed such that the key process variables (KPVs) are observ...
متن کاملCeramic Injection Molding
Powder injection molding (PIM), which encompasses metal injection molding (MIM) and ceramic injection molding (CIM), is a net-shaping process which enables large scale production of complex-shaped components for use in a diverse range of industries. It combines plastic injection molding techniques and performance attributes of ceramic and metal powders. Ceramic injection molding (CIM) uses cera...
متن کاملInjection Compression Molding of Replica Molds for Nanoimprint Lithography
As a breakthrough in the cost and durability of molds for nanoimprint lithography (NIL), replica molds are fabricated by injection compression molding (ICM). ICM is commonly used for optical disks such as DVDs or Blu-ray disks and is also a practical fabrication method for nanostructures. In this paper, I successfully demonstrated the fabrication of cycloolefin polymer replica molds with struct...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Elastomers and Composites
سال: 2012
ISSN: 2092-9676
DOI: 10.7473/ec.2012.47.4.341