A Study on RF Receiver Design and Analysis of Digital Radar Receiver
نویسندگان
چکیده
منابع مشابه
Superconductor Digital-RF Receiver Systems
Digital superconductor electronics has been experiencing rapid maturation with the emergence of smaller-scale, lower-cost communications applications which became the major technology drivers. These applications are primarily in the area of wireless communications, radar, and surveillance as well as in imaging and sensor systems. In these areas, the fundamental advantages of superconductivity t...
متن کاملa study on the design of bio-ethanol process from date wastes of sistan and baluchistan province
اتانول کاربردهای متنوعی در صنایع لاستیک سازی، رنگسازی، حلالها ومکمل سوخت خودرو دارد. اتانول برخلاف نفت از جمله مواد تجدیدپذیر محسوب می شود که مشکلات زیست محیطی و آلودگی نیز ایجاد نمی کند. استفاده از اتانول به عنوان مکمل سوختخودروها از جمله مهمترین مصارف صنعتی این ماده بشمار می رود. با توجه به این موضوع تحقیق و توسعه در زمینه تولید اتانول با درجه خلوص بالا در سطح جهان، و نه تنها در کشور های پیشر...
A Digital Down Converter for a Wideband Radar Receiver
In a conventional radar receiver errors are introduced due to mismatch between the ADCs and gain and phase mismatch in the I/Q demodulation. By performing the I/Q demodulation in the digital domain some of these errors are alleviated. In this paper several different filter structures suitable for digital I/Q demodulation are evaluated. Three different structures for such a digital down converte...
متن کاملDesign Analysis and Comparative Study of Rf Receiver Front-ends in 0.18-μm Cmos
In this work, design and simulation results of two RF front-ends to be used in direct conversion receiver are presented. The first one uses dual CS differential LNA with folded mixer. The second one uses single-ended LNA with double balanced mixer. Single-ended and fully differential LNA’s provide gains of 16.3 dB and 28.75 dB at 2.4GHz, respectively. Noise Figure of these two LNA’s are 3.34 dB...
متن کاملUHF RF Transmitter and Receiver
Here we propose a current mode oscillator circuit using Q-Dot technology and subsequently we modify this circuit for transmitter and receiver design. We like to note that transmitter is a amplitude modulation (AM) to frequency modulation (FM) conversion technique. The receiver is of Super heterodyne structure, where the RF front end is implemented by Q-Dot devices and the IF stages are implemen...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of Korean Institute of Electromagnetic Engineering and Science
سال: 2014
ISSN: 1226-3133
DOI: 10.5515/kjkiees.2014.25.3.282