A STUDY ON LOAD CARRYING CAPACITY AND PLASTIC DEFORMATION CAPACITY OF BEAM-TO-COLUMN CONNECTIONS COMPOSED OF H-SHAPED MEMBERS MADE OF COMPARATIVELY THIN PLATES : Part 1 Load carrying capacity and plastic deformation capacity of beam-to-column connection in monotonic loadings
نویسندگان
چکیده
منابع مشابه
Load Carrying Capacity of Simply Supported Variable Thickness Circular Plates
The calculation of the load carrying capacity of variable thickness circular plates subjected to arbitrary rotational symmetric loading is presented. The analysis considers plate materials that obey either the square or the Tresca yield criterion. By using upper and lower bound theorems of limit analysis, corresponding estimations for the load carrying capacity of the plate are obtained. It is ...
متن کاملOptimal Trajectory of Flexible Manipulator with Maximum Load Carrying Capacity
In this paper, a new formulation along with numerical solution for the problem of finding a point-to-point trajectory with maximum load carrying capacities for flexible manipulators is proposed. For rigid manipulators, the major limiting factor in determining the Dynamic Load Carrying Capacity (DLCC) is the joint actuator capacity. The flexibility exhibited by light weight robots or by robots o...
متن کاملUltimate Load Capacity and Behavior of Thin-Walled Curved-Steel Square Struts, Subjected to Compressive Load
There have been some experimental tests on hollow curved-steel struts with thin-walled square sections, in order to investigate their general behavior, particularly their capacity for bearing differing loads. One set of square tubes are cold-formed into segments of circular arcs with curvature radii, equal to 4000 mm. Different lengths of curved struts are fabricated so as to cover a practical ...
متن کاملDynamic Load Carrying Capacity of Flexible Manipulators Using Finite Element Method and Pontryagin’s Minimum Principle
In this paper, finding Dynamic Load Carrying Capacity (DLCC) of flexible link manipulators in point to-point motion was formulated as an optimal control problem. The finite element method was employed for modelling and deriving the dynamic equations of the system. The study employed indirect solution of optimal control for system motion planning. Due to offline nature of the method, many diffic...
متن کاملAnalytical and Experimental Investigation of I Beam-to-CFT Column Connections under Monotonic Loading (RESEARCH NOTE)
In this study, the behavior characteristics of I beam-to-concrete filled tube (CFT) column connection is studied through experiment and finite element models under the monotonic loading. To validate the finite element modeling, at first, an experimental model is made and experimented. After validation of the finite element modeling, different models were created in the software. The studied par...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Structural and Construction Engineering (Transactions of AIJ)
سال: 1987
ISSN: 0910-8025,2433-0000
DOI: 10.3130/aijsx.375.0_43