A study of 3D finite element modeling method for stagger spinning of thin-walled tube
نویسندگان
چکیده
منابع مشابه
Analysis of Thin-Walled Steel Sections Filled with Concrete Using Non-Linear Finite Element Method
Being economical and performing well under cyclic loads, steel sections filled with concrete have been widely used in structural buildings. Extensive studies and experiments have been conducted to investigate the influence of different parameters and loadings on the behavior of these structural components. Based on the data available from previous experiments and studies, this paper discusses t...
متن کاملAnalysis of Thin-Walled Steel Sections Filled with Concrete Using Non-Linear Finite Element Method
Being economical and performing well under cyclic loads, steel sections filled with concrete have been widely used in structural buildings. Extensive studies and experiments have been conducted to investigate the influence of different parameters and loadings on the behavior of these structural components. Based on the data available from previous experiments and studies, this paper discusses t...
متن کاملA study on behavior of block pavement using 3D finite element method
Three dimensioned finite element analysis were conducted on concrete block paving. In order to verify the calculated results, an experimental case study was analyzed. Good agreement was observed between the measured and the calculated results. Based on the finite element analysis results and available failure models, comprehensive design charts were developed for port and industrial pavement wh...
متن کاملFinite Element Modeling and Experimental Study of the Spline Tube Forming
Metal forming processes, compared with machining ones, reduce production steps and increase manufacturing speed in addition to saving raw material. In this paper, forming process of column of a steering mechanism is investigated by finite element analyses and experimental tests; and optimum die design parameters are found. Forming process parameters including die opening angle, bearing length, ...
متن کاملFinite Element Modeling and Experimental Study of the Spline Tube Forming
Metal forming processes, compared with machining ones, reduce production steps and increase manufacturing speed in addition to saving raw material. In this paper, forming process of column of a steering mechanism is investigated by finite element analyses and experimental tests; and optimum die design parameters are found. Forming process parameters including die opening angle, bearing length, ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Zhejiang University-SCIENCE A
سال: 2016
ISSN: 1673-565X,1862-1775
DOI: 10.1631/jzus.a1500180