A Simulation of Cylindrical Plunge Grinding Process (1st Report)
نویسندگان
چکیده
منابع مشابه
Realisation of grinding-hardening in workpieces of curved surfaces—Part 1 Plunge cylindrical grinding
This paper investigates the feasibility to achieve grinding-hardening in a plunge cylindrical grinding process. To understand the mechanisms, a temperature-dependent finite element heat transfer model incorporating a triangular moving heat source was developed to describe the temperature field, thus to predict the thickness of the grinding-hardened layer. The analysis carried out included the v...
متن کاملStudy of Traverse Grinding Process (1st Report) Accumulation Phenomenon and Size Generation Mechanism in Traverse Grinding
plicated processes on the wheel surf ace along the wheel width. In order to make these processes clear, the experimental analysis of traverse grinding was conducted by widely changing the speed ratio, Kv, the setting depth of wheel, ‡TMT, and the number of total steps, m, (the ratio of the wheel width over the traverse feed per one revolution of the workpiece). The following results were obtain...
متن کاملParametric optimization of cylindrical grinding process through hybrid Taguchi method and RSM approach using genetic algorithm
The present investigation proposes a hybrid technique: Taguchi method, response surface methodology (RSM) and genetic algorithm (GA), to analyze, model and predict vibration and surface roughness in traverse cut cylindrical grinding of aluminum alloy. Experiments have been conducted as per L9 orthogonal array of Taguchi methodology using several levels of the grinding parameters. Analysis of va...
متن کاملNonlinear Modelling and Simulation of Industrial Wet Grinding Process
The multiple linear models based piece-wise linearization approach is used to obtain control-oriented non-linear model of the non-linear multivariable wet grinding process of an industrial lead-zinc ore beneficiation plant. The overall process outputs are computed as a weighted sum of outputs from multiple models identified at several operating zones. The output weights of linear models are com...
متن کاملMicro Cutting Simulation of Abrasive Grains in the Grinding Process
In the current work we present approach to study the mechanism of the cutting of abrasive grains in the grinding wheel using finite element analysis (FEA). The simulation process is done by separating two abrasive grains from the grinding wheels and the microprocess of material removal in the case of surface grinding is simulated. Modelling was done on the workpiece steel S-7 and material grain...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 1994
ISSN: 0912-0289,1882-675X
DOI: 10.2493/jjspe.60.808