A Simply Fabricated Neural Probe by Laser Machining of a Thermally Laminated Gold Thin Film on Transparent Cyclic Olefin Polymer

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Transparent, conductive ZnO:Al thin film deposited on polymer substrates by RF magnetron sputtering

In this paper, we present the optical, electrical, structural and mechanical properties exhibited by aluminum-doped zinc oxide (ZnO:Al) thin films produced by RF magnetron sputtering on polymeric substrates (polyethylene terephthalate, PET; Mylar type D from Dupont ) with a standard thickness of 100 mm. The influence of the uniaxial tensile strain on the electrical resistance of these films was...

متن کامل

Fully transparent flexible tin-doped zinc oxide thin film transistors fabricated on plastic substrate

In this work, we have successfully fabricated bottom gate fully transparent tin-doped zinc oxide thin film transistors (TZO TFTs) fabricated on flexible plastic substrate at low temperature by RF magnetron sputtering. The effect of O2/Ar gas flow ratio during channel deposition on the electrical properties of TZO TFTs was investigated, and we found that the O2/Ar gas flow ratio have a great inf...

متن کامل

Development of a biosensor based on laser-fabricated polymer microcantilevers

We develop high-sensitivity biosensors based on microcantilevers. The polymer microcantilevers are fabricated by fast and cost-effective laser machining processes. Polymer film is selected because it gives better sensitivity of deflection measurements than silicon due to its lower Young’s modulus and also its cost is much lower. We demonstrate using these polymer microcantilevers for biological...

متن کامل

Surface Wettability Modification of Cyclic Olefin Polymer by Direct Femtosecond Laser Irradiation

The effect of laser irradiation on surface wettability of cyclic olefin polymer (COP) was investigated. Under different laser parameters, a superhydrophilic or a superhydrophobic COP surface with a water contact angle (WCA) of almost 0° or 163°, respectively, could be achieved by direct femtosecond laser irradiation. The laser power deposition rate (PDR) was found to be a key factor on the wett...

متن کامل

a study on insurer solvency by panel data model: the case of iranian insurance market

the aim of this thesis is an approach for assessing insurer’s solvency for iranian insurance companies. we use of economic data with both time series and cross-sectional variation, thus by using the panel data model will survey the insurer solvency.

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: ACS Omega

سال: 2019

ISSN: 2470-1343,2470-1343

DOI: 10.1021/acsomega.8b03682