A silicon condenser microphone with a silicon nitride diaphragm and backplate

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Implementation of the CMOS MEMS Condenser Microphone with Corrugated Metal Diaphragm and Silicon Back-Plate

This study reports a CMOS-MEMS condenser microphone implemented using the standard thin film stacking of 0.35 μm UMC CMOS 3.3/5.0 V logic process, and followed by post-CMOS micromachining steps without introducing any special materials. The corrugated diaphragm for the microphone is designed and implemented using the metal layer to reduce the influence of thin film residual stresses. Moreover, ...

متن کامل

A High Sensitivity Polysilicon Diaphragm Condenser Microphone

This paper presents the analysis, design, fabrication, and testing of a condenser microphone utilizing a thin low-stress polycrystalline silicon diaphragm suspended above a p+ perforated back plate. The microphone is fabricated using a combination of surface and bulk micromachining techniques in a single wafer process without the need of wafer bonding. The device shows sensitivities of -34 dB (...

متن کامل

Pattern Photoresist Silicon Silicon Nitride Silicon Photoresist Silicon Nitride Silicon Etch Nitride Remove Photoresist

In this proposal we seek to establish a porous silicon based etching process in the WTC microfabrication laboratory. The new process will allow us to etch high aspect ratio holes through a wafer. Holes like these are important for decreasing the dead volume of connections between micro and macro systems and for increasing the complexity of micro-fluidic systems. At the present time, the minimum...

متن کامل

2b2.07pl a Polymer Condenser Microphone on Silicon with On-chip Cmos Amplifier

In this paper the development of a capacitive microphone with integrated preamplifier is described. The condenser microphone is made by micromachining of polyimide on silicon, and is compatible with CMOS technology. Therefore, the structure can be realised by post processing on substrates containing integrated circuits, independently of the IC process. Microphones with a required DC bias voltag...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Micromechanics and Microengineering

سال: 1992

ISSN: 0960-1317,1361-6439

DOI: 10.1088/0960-1317/2/3/016