A sensitive analog comparator

نویسندگان

چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

All-optical analog comparator

An analog comparator is one of the core units in all-optical analog-to-digital conversion (AO-ADC) systems, which digitizes different amplitude levels into two levels of logical '1' or '0' by comparing with a defined decision threshold. Although various outstanding photonic ADC approaches have been reported, almost all of them necessitate an electrical comparator to carry out this binarization....

متن کامل

Comparator-based switched-capacitor pipelined analog-to-digital converter with comparator preset, and comparator delay compensation

We present a differential comparator-based switched-capacitor (CBSC) pipelined analog-to-digital converter (ADC) with comparator preset, and comparator delay compensation. Compensating for the comparator delay by digitally adjusting the comparator threshold improves the ADC resolution from 2.5-bit to 7.05-bit. The ADC is manufactured in a 90 nm CMOS technology, with a core area of 0.85 mm 9 0.3...

متن کامل

High-speed low-power comparator for analog to digital converters

Article history: Received 28 July 2015 Accepted 1 April 2016

متن کامل

1-V CMOS Comparator for Programmable Analog Rank-Order Extractor

A CMOS rail-to-rail comparator operating at low-voltage supply by using a conventional fabrication process is proposed. Based on the comparator, an analog rank-order extractor with winner-take-all capability is presented. An experimental chip was fabricated using 0.5 m CMOS technology. Measured results at 1–V supply voltage show a comparator response time of 4 s for 10-mV precision and that the...

متن کامل

A New Design of Fault Tolerant Comparator

In this paper we have presented a new design of fault tolerant comparator with a fault free hot spare. The aim of this design is to achieve a low overhead of time and area in fault tolerant comparators. We have used hot standby technique to normal operation of the system without interrupting and dynamic recovery method in fault detection and correction. The circuit is divided to smaller modules...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: IEEE Transactions on Instrumentation and Measurement

سال: 1982

ISSN: 0018-9456,1557-9662

DOI: 10.1109/tim.1982.6312486