A Research of Selective Catalytic Reduction of NOx with NH3 by Using Novel Catalysts

The Selective Catalytic Reduction of NOx with NH3 over Titania Supported Rhenium Oxide Catalysts

Titania supported vanadium oxide catalysts have been demonstrated to be very efficient catalysts for the selective reduction of NOx with NH3 and have found widespread industrial application for the control of NOx emissions from stationary sources (1). Characterization studies have demonstrated that supported vanadium oxide catalysts consist of a two-dimensional metal oxide overlayer on the oxid...

Low temperature selective catalytic reduction of NOx with NH3 over Mn-based catalyst: A review

The removals of NOx by catalytic technology at low temperatures (100–300 °C) for industrial flue gas treatment have received increasing attention. However, the development of low temperature catalysts for selective catalytic reduction (SCR) of NOx with ammonia is still a challenge especially in the presence of SO2. The current status of using Mn-based catalysts for low temperature SCR of NOx wi...

Promotional effect of Si-doped V2O5/TiO2 for selective catalytic reduction of NOx by NH3.

TiO2 supports doped with different amounts of Si were prepared by a sol-gel method, and 1 wt% vanadia (V2O5) loaded on Si-doped TiO2 was obtained by an impregnation method. The mole ratio of Si/Ti was 0.2, NOx conversion exceeds 94% at 300 degrees C and GHSV of 41,324 hr(-1), which is about 20% higher than pure V2O5/TiO2. The catalysts were characterized by XRD, BET, TEM, FT-IR, NH3-TPD, XPS, H...

Novel manganese oxide confined interweaved titania nanotubes for the low-temperature Selective Catalytic Reduction (SCR) of NOx by NH3

Promotional Effect of Ce on Iron-Based Catalysts for Selective Catalytic Reduction of NO with NH3

A series of Fe–Ce–Ti catalysts were prepared via co-precipitation method to investigate the effect of doping Ce into Fe–Ti catalysts for selective catalytic reduction of NO with NH3. The NO conversion over Fe–Ce–Ti catalysts was considerably improved after Ce doping compared to that of Fe–Ti catalysts. The Fe(0.2)–Ce(0.4)–Ti catalysts exhibited superior catalytic activity to that of Fe(0.2)–Ti ...