A REBCO Persistent-Current Switch (PCS): Test Results and Switch Heater Performance
نویسندگان
چکیده
منابع مشابه
Modular Multilevel Current Source Inverter Using Two-Switch Basic Units
This article is an introduction of a new topology of current source inverter (CSI) which can be alternatively implemented in low/medium power applications. This configuration is organized from series connected sub-multilevel inverters blocks. The basis of the recommended multilevel topology is the connections of many cell units in a decent scheme with the help of H-bridge inverter. The suggeste...
متن کاملSwitch-level delay test
Gate-level models are usually used to generate tests for circuits containing non-primitive CMOS gates. It is shown that tests generated using these models and classical conditions for robust path delay testing can fail to detect delay faults in such circuits. A new delayindependent, switch-level delay test methodology, called -robust testing, is proposed that de nes new entities called targets ...
متن کاملA High-Speed Fully Differential Current Switch
A high-speed fully differential current switch is presented. The clock-feedthrough effect is reduced by Swing-Reduced Drivers and neutralized by dummy transistors. With the use of Swing-Reduced Drivers (SRD), less charges are required to be transferred to/from the gates of the switching transistors, and hence, the switching speed can be increased without significant output error. The SRDs also ...
متن کاملA Switch-Level Test Generation System
This paper presents a switch-level test generation system for synchronous sequential circuits in which a new algorithm for switch-level test generation and an existing fault simulator are integrated. For test generation, a switch-level circuit is modeled as a logic network that correctly models all aspects of switch-level behavior. The time-frame based algorithm uses asynchronous processing wit...
متن کاملAnalysis of drain Current and Switching Speed for SPDT Switch and Dpdt Switch with the Proposed DP4T RF CMOS Switch
Conventional CMOS switch uses NMOS as transistors in its main architecture requiring a control voltage of 5.0V and a large resistance at the receivers and antennas (ANTs) to detect the signal. A CMOS integrated circuit switch uses FET transistors to achieve switching between multiple paths, because of its high value of control voltage. Hence it is not suitable for modern portable devices which ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Applied Superconductivity
سال: 2017
ISSN: 1051-8223,1558-2515
DOI: 10.1109/tasc.2017.2652303