A pulse-height compensation system for Ge(Li) Timing
نویسندگان
چکیده
منابع مشابه
Alcator C - Mod Soft X - Ray Pulse Height Analysis System
A pulse height analysis (PHA) system has been installed on the Alcator C-Mod magnetic confinement fusion experiment. The PHA utilizes a Si(Li) detector to measure soft X-rays in the 1-30 keV range with an energy resolution on the order of 100eV. A FASTComtec MCA-3 multichannel analyzer allows integration times of ims while the PHA supports counting rates of up to 80kHz. The thermal electron tem...
متن کاملOptimal Roll Center Height of Front McPherson Suspension System for a Conceptual Class A Vehicle
In this paper, the effects of roll center height of McPherson suspension mechanism on dynamic behaviour of a vehicle are first studied, and then the optimum location of roll center of this suspension system is determined for a conceptual Class A vehicle. ADAMS/Car software was used for the analysis of vehicle dynamic behaviour in different positions of suspension roll center. Next, optimization...
متن کاملA Phase Compensation Algorithm for High-resolution Pulse Radar Systems
1. Introduction Many studies have been done to develop high-resolution algorithms for pulse radar systems [1–7], which can be applicable for many kind of applications including rescue robots. High-resolution algorithms utilize not only the envelope of the received signal but also the phase of carrier signal. However, it should be noted that the received carrier phase depends on the shape of tar...
متن کاملA Monte Carlo Code for Simulation of Pulse Pile-up Spectral Distortion in Pulse-height Measurement
The Monte Carlo simulation code CEARPPU has been improved to obtain better accuracy for predicting pulse-height spectra measured at high counting rates. Experimental verification was carried out by measuring an Fe-55 spectrum with a Si(Li) X-ray spectrometer. Based on the spectrum measured at low counting rate, which is considered to be the “true” spectrum with no pulse pile-up distortion, the ...
متن کاملPulse reverse plating for uniform nickel height in zone plates
Nickel soft x-ray zone plates are fabricated by through-mask electroplating. The authors report on how a uniform nickel thickness can be obtained over the entire zone plate using pulse and pulse reverse plating. If the plating is carried out at a constant current the nickel thickness has been observed to decrease with radius. This results in lower outer zones and reduced diffraction efficiency ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nuclear Instruments and Methods
سال: 1969
ISSN: 0029-554X
DOI: 10.1016/0029-554x(69)90580-1