A Picosecond Resolution Time Digitizer for Laser Ranging
نویسندگان
چکیده
منابع مشابه
Laser Digitizer Based Strain Measurement
Automotive sheet panel strain measurement usually involves large surface areas. For high resolution analysis, using the circle grid analysis method, several hundred elements must be measured. Existing technologies are limited to the small surface that area can be measured in one setup. As well, the (X,Y,Z) location on the part is not accurately available. This paper reports a new surface strain...
متن کاملA Time Digitizer CMOS Gate-Array with a 250 ps Time Resolution
A pipelined time digitizer CMOS gate-array has been developed using 0.5 μm Sea-of-Gate technology. Precise timing signals which are used to sample input signals are generated from 32 taps of an asymmetric ring oscillator. The frequency of the oscillator is controlled by a PLL circuit which runs in the 10 50 MHz frequency range. A test chip has been developed and tested; a time resolution of 250...
متن کاملReview of methods for time interval measurements with picosecond resolution
This paper is a review of methods and techniques used for precise measurement of time intervals (TIs) or precise conversion of TIs to digital data. The following methods are described: the counter method and averaging, time stretching, time-to-amplitude conversion followed by analogue-to-digital conversion, the Vernier method, conversion utilizing tapped delay lines, and interpolation methods. ...
متن کاملPicosecond-resolution soft-x-ray laser plasma interferometry.
We describe a soft-x-ray laser interferometry technique that allows two-dimensional diagnosis of plasma electron density with picosecond time resolution. It consists of the combination of a robust high-throughput amplitude-division interferometer and a 14.7-nm transient-inversion soft-x-ray laser that produces approximately 5-ps pulses. Because of its picosecond resolution and short-wavelength ...
متن کاملReal-time optical measurements with picosecond resolution during laser induced transformations
This work describes a novel technique allowing to measure with picosecond resolution the time evolution of the optical properties ~reflectivity/transmission! of a material surface exposed to a single laser pulse. The experimental setup is based on the use of a streak camera in combination with a single-mode probe cw laser. The maximum achievable time resolution is about 1 ps for the acquisition...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Nuclear Science
سال: 1978
ISSN: 0018-9499
DOI: 10.1109/tns.1978.4329280