A Passively Q-Switched Holmium-Doped Fiber Laser with Graphene Oxide at 2058 nm
نویسندگان
چکیده
This study reports a Q-switching-based, 2058-nm holmium (Ho) fiber laser incorporating saturable absorber (SA) based on graphene oxide (GO). The SA was prepared with side-polished fiber, while GO particles were deposited onto the fiber-polished surface to realize an all-fiber SA. A continuous-wave thulium-doped laser, which configured master-oscillator power-amplifier (MOPA) structure, constructed as pumping source. By inserting fabricated into ring resonator 1-m length of Ho-doped Q-switched pulses could readily be obtained at wavelength 2058 nm. pulse width observed vary from 2.01 1.56 μs pump power adjusted ~759 1072 mW, repetition rate tunable 45.56 56.12 kHz. maximum values average optical and energy measured ~11.61 mW 207.05 nJ, respectively, ~1072 power.
منابع مشابه
Millijoule-level Yb-doped photonic crystal fiber laser passively Q-switched with AlGaInAs quantum wells.
We report on a millijoule-level Yb-doped photonic crystal fiber (PCF) laser passively Q-switched with AlGaInAs quantum wells (QWs). Three types of AlGaInAs devices with different QW numbers are fabricated to investigate the performance. With 50 groups of three AlGaInAs QWs as a saturable absorber (SA), the PCF laser generates an average power of 7.1 W with a pulse repetition rate of 6.5 kHz at ...
متن کاملHybrid Q-switched Yb-doped fiber laser.
We investigate the performance of a hybrid Q-switched (HQS) fiber laser that is constructed with a low RF-power driven acousto-optic (AO) Q-switch and an AlGaInAs semiconductor saturable absorber. Compared to a pure passively Q-switched (PQS) fiber laser, the ratio of timing jitter to pulse period can be significantly reduced from 2% to 0.3% in the regime of far above threshold. On the other ha...
متن کاملA Q-switched erbium-doped fiber laser with a graphene saturable absorber - IOPscience
We demonstrate a simple, compact and low cost Q-switched erbium-doped fiber laser (EDFL) exploiting a graphene saturable absorber (GSA) for possible applications in metrology, sensing and medical diagnostics. The EDFL operates at 1560 nm with repetition rates of 31.3 kHz and 25 kHz with GSA1 and GSA2, respectively, at pump power of 120 mW. The repetition rate is smaller with a lower pump power....
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied sciences
سال: 2021
ISSN: ['2076-3417']
DOI: https://doi.org/10.3390/app11010407