A parametric fault displacement model to introduce kinematic control into modeling faults from sparse data
نویسندگان
چکیده
منابع مشابه
A Diagnostic Model For Identifying Parametric Faults
This paper considers a new approach to fault detection and isolation (FDI) for systems modeled as an interconnection of subsystems that are each subject to parametric faults. The paper develops i) the concept of a diagnostic model that parameterizes all possible subsystem faults, ii) an off-line scheme for identification of the diagnostic model, iii) a parity equation that results in a residual...
متن کاملdevelop a non-parametric model to simulate monthly hydrological data
one of the water resources modeling requirements is sufficient knowledge of long-term series of meteorological and hydrological parameters. in this study the nearest neighbor resampling method presented by lall and sharma was developed. in the developed model, the knn regression was used for time series forecasting instead of local polynomial used in the developed algorithm by prairie. in this ...
متن کاملSegment delay faults: a new fault model
We propose a segment delay fault model to represent any general delay defect ranging from a spot defect to a distributed defect. The segment length, L, is a parameter that can be chosen based on available statistics about the types of manufacturing defects. Once L is chosen, the fault list contains all segments of length L and paths whose entire lengths are less than L. Both rising and falling ...
متن کاملA Qualitative Fault Isolation Approach for Parametric and Discrete Faults Using Structural Model Decomposition
With increasing complexity of engineering systems, fault diagnostics plays a significant role in ensuring that they operate safely. Such systems most often exhibit mixed discrete and continuous, i.e., hybrid, behavior, and may encounter both parametric faults (unexpected changes in system parameters) as well as discrete faults (unexpected changes in component modes). Diagnosis becomes computati...
متن کاملFault compaction and overpressured faults: results from a 3-D model of a ductile fault zone
S U M M A R Y A model of a ductile fault zone is incorporated into a forward 3-D earthquake model to better constrain fault-zone hydraulics. The conceptual framework of the model fault zone was chosen such that two distinct parts are recognized. The fault core, characterized by a relatively low permeability, is composed of a coseismic fault surface embedded in a visco-elastic volume that can cr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Interpretation
سال: 2018
ISSN: 2324-8858,2324-8866
DOI: 10.1190/int-2017-0059.1