A NUMERICAL MODEL OF WAVE DEFORMATION IN SURF ZONE
نویسندگان
چکیده
منابع مشابه
Numerical Investigation of Circular Plates Deformation under Air Blast Wave
In the current research the maximum deflection of circular plates made of AA5010 and AA1100 alloys under blast load was investigated. Shock waves were produced by exploding a spherical charge in different distances from the center of plates. The ABAQUS software uses conwep equation for blast loading analysis. It was found the results of these simulations have about 30% to 40% inaccuracy in comp...
متن کاملWave Group Forcing of Low Frequency Surf Zone Motion
The nearshore potential vorticity balance of Bowen and Holman (1989) is expanded to include the forcing from wave group-induced radiation stresses. Model results suggest that the forcing from these radiation stresses can drive oscillations in the longshore current that have a spatial structure similar to linear shear instabilities of the longshore current. In addition, the forced response is ne...
متن کاملSurf Zone Wave Breaking Identification Using Marine Radar
This paper presents a novel combination of synchronous, large coverage marine radar, calibrated pulsed Doppler radar, and video remote sensing observations from a nearshore field site. The data enable the analysis of the evolution and characteristics of the remotely observed signals from surf zone waves. The combination of different remote sensors allows a better discrimination between breaking...
متن کاملScaling surf zone turbulence
[1] Turbulence in the surf zone, the shallow region adjacent to the shoreline, has a key role in beach erosion, fertilization, dispersal, and larval settlement of marine invertebrates, and microbial contamination dilution in beach waters. Breakingwave generated (the dominant source) surf zone turbulence is understood poorly. A new surf zone turbulent dissipation rate scaling is derived, that co...
متن کاملWall stress and deformation analysis in a numerical model of pulse wave propagation.
To simulate pulse wave propagation, we set up a wave propagation model using blood-wall interaction in previous work. In this paper, our purpose is to investigate wall stress and deformation of the wave propagation model. The finite element method is employed for solving the governing equations of blood and wall. Our results suggest that there are two peaks in the circumferential stress and str...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Coastal Engineering Proceedings
سال: 1988
ISSN: 2156-1028,0589-087X
DOI: 10.9753/icce.v21.41