منابع مشابه
Vector-Network-Analyzer Calibrations
We develop an uncertainty analysis that captures the dominant sources of measurement error in state-of-the-art WM-380 (WR 1.5) rectangular-waveguide vector-network-analyzer measurements over the frequency range 500–750 GHz. We use the analysis to assess thru-reflect-line, thru-short-match, and thru-short-radiating-open calibrations. The comparison shows that thru-short-match and thru-short-radi...
متن کاملLow-cost Vector Network Analyzer for Biomedical Applications
A low-cost and portable vector network analyzer (VNA) which covered operating frequency between 1MHz to 3GHz is used for vector reflection coefficient and standing wave ratio (swr) of the various microstrip antennas. This paper presents measurements of various ultra wideband (uwb) microstrip antennas for applications in biomedical field. Selection of antenna is an important key for detection of...
متن کاملElectronic Vector - Network - Analyzer Verification ■
118 October 2009 Digital Object Identifier 10.1109/MMM.2009.933595 The National Institute of Standards and Technology (NIST) recently introduced a new electronic approach for verifying microwave vectornetwork-analyzer (VNA) calibrations with a single computer-controlled electronic verifi cation artifact. The verifi cation results are captured in easy-tounderstand performance metrics that, unlik...
متن کاملComparing Nonlinear Vector Network Analyzer Methodologies
Scattering parameters (S-parameters) were first mentioned in articles and textbooks in the 1950s and 1960s by Matthews, Collins and Kurokawa and popularized by the release of Hewlett Packard’s first network analyzers in the 1960s. Since then, S-parameters have been used to describe the complex characteristics of a network by quantifying the RF power flowing between its ports. S-parameters are e...
متن کاملSeven State PTP for Vector Network Analyzer
A new, seven-state switched perturbation twoport (PTP) for vector reflection measurement based on scalar measurement only was designed and realized in microstrip structure using PIN diodes. The structure was experimentally tested by means of vector measurements of different impedances in frequency band with relative bandwidth of 2.5 octaves. Good agreement with data obtained using a precise vec...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Microwave Theory and Techniques
سال: 1998
ISSN: 0018-9480
DOI: 10.1109/22.739243