A Novel Fault Tolerant Machine With Integral Slot Non-Overlapping Concentrated Winding
نویسندگان
چکیده
منابع مشابه
Six Phase Permanent Magnet Machine with Fractional Slot Concentrated Winding
Permanent Magnet Machines (PMM) with a phase number (m) higher than three allow redundancy and lower torque ripple compared to their three phase counterparts. In this paper, a six phase permanent magnet machine with surface rotor magnets, designed with fractional slot tooth winding is proposed. A stator design with fractional slot tooth winding allows the design of a compact machine through sho...
متن کاملPerformance Analysis of a Novel Three-phase Axial Flux Switching Permanent Magnet Generator with Overlapping Concentrated Winding
This paper proposes a novel axial flux switching permanent magnet generator for small wind turbine applications. Surface mounted axial flux switching permanent magnet (SMAFSPM) machine is a new type of these machines that is introduced in this paper. One of the most important challenges in optimal designing of this kind of machines, is ease of construction and maintenance. One of the main featu...
متن کاملInterior permanent magnet motors with non-overlapping concentrated windings or with integral slot windings for traction application
These Interior permanent magnet machines using integral slot windings or non-overlapping concentrated windings are designed for traction applications. Four direct drive traction motors are analyzed: two 25 kW motors and two 100 kW motors at rated speed of 1000 min. Analytical computations are verified by finite element analysis utilizing Cedrat’s Flux2D. Concentrated tooth coil winding machines...
متن کاملInvestigation on Slot–Pole Combinations of a PM Vernier Motor with Fractional-Slot Concentrated Winding Configurations
This paper presents a new method to find available slot–pole combination of a permanent magnet (PM) vernier motor with fractional-slot concentrated winding (FSCW) configurations instead of the conventional design rule. To this aim, for a common structure of PM vernier machines with FSCW, the air gap flux densities including modulation flux due to vernier effects are investigated from the magnet...
متن کاملSensor and Actuator Fault-Tolerant Control Scheme applied to a Winding Machine
A conventional feedback control design may result in unsatisfactory performances in the event of malfunctions in actuators, sensors or other components of the system. This paper deals with the analysis and the design of the fault-tolerant control (FTC) in case of actuators and sensors faults. A classification of the FTC methods is proposed and according to the severity of faults affecting the s...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Access
سال: 2019
ISSN: 2169-3536
DOI: 10.1109/access.2019.2931083