A New Zero-Voltage-Switching Bridgeless PFC, Using an Active Clamp
نویسندگان
چکیده
منابع مشابه
Zero-Voltage and Zero-Current-Switching Full-Bridge PWM Converter Using Secondary Active Clamp
A new zero-voltage and zero-current-switching (ZVZCS) full-bridge (FB) pulsewidth modulation (PWM) converter is proposed to improve the performance of the previously presented ZVZCS FB PWM converters. By adding a secondary active clamp and controlling the clamp switch moderately, ZVS (for leading-leg switches) and ZCS (for lagging-leg switches) are achieved without adding any lossy components o...
متن کاملNew Bridgeless DCM Sepic PFC Rectifier with Low Conduction and Switching Losses
New bridgeless single-phase ac–dc power factor correction (PFC) rectifier based on Sepic topology is proposed. The absence of an input diode bridge and the presence of only two semiconductor switches in the current flowing path during each switching cycle result in less conduction losses and improved thermal management compared to the conventional Sepic PFC converter. The proposed topology is d...
متن کاملBridgeless Isolated Cuk PFC Implementation using PID and Neural Controller
The comparision of bridgeless isolated cuk converter using proportional integral derivative (PID) and neural controller (NC) is presented in this paper. Due to diode bridge rectifier (DBR) conventional converters suffer from high conduction loss. Bridgeless Cuk converter is used to eliminate the issues. bridgeless isolated (BLI) cuk converter is used to withstand high voltage. Compare to Contin...
متن کاملA New Zero-Voltage-Switching Push-Pull Converter
A soft switching three-transistor push-pull(TTPP)converter is proposed in this paper. The 3rd transistor is inserted in the primary side of a traditional push-pull converter. Two primitive transistors can achieve zero-voltage-switching (ZVS) easily under a wide load range, the 3rd transistor can also realize zero-voltage-switching assisted by leakage inductance. The rated voltage of the 3rd tra...
متن کاملAn AC/DC PFC Converter with Active Soft Switching Technique
This paper proposes an AC-DC converter with the application of active type soft switching techniques. Boost converter with active snubber is used to achieve power factor correction. Boost converter main switch uses Zero Voltage Transition switching for turn on and Zero Current Transition switching for turn off. The active snubber auxillary switch uses Zero Current Switching for both turn on and...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Power Electronics
سال: 2012
ISSN: 1598-2092
DOI: 10.6113/jpe.2012.12.5.723