A New Type of Motor: Pneumatic Step Motor
نویسندگان
چکیده
منابع مشابه
A Novel Disc-Type Reluctance Motor
This paper explores the theory and potential of a family of reluctance motors as well as brief review of different types of reluctance motors, motivated by the increased demands for geometric versatility and ruggedness for electric motors. This paper presents a new and novel disc type reluctance motor that has been designed built, tested, and analyzed. The magnetic circuit-based analysis shows ...
متن کاملSimulation of a Variable Reluctance Steping Motor for Sinusoidal and Step Exitations
Steady-state dynamic simulation of a variable reluctance stepping motor is carried out by applying two different excitation voltages. First a single-step voltage is applied to the motor, and a sinusoidal voltage, as the first term of Fourier series of the single-step voltage, is then used as the input voltage of the motor. In both cases plots of machine torque, current and speed are presented. ...
متن کاملA New Skewed-Rotor-Pole Switched Reluctance Motor Design
This paper considers a new switched reluctance motor (SRM) structure aiming at high starting torque with low volume. For some applications such as EVs (Electrical Vehicles), the motor volume and starting torque is a critical point in its design. In many methods, reducing the motor volume causes reduction in starting torque and decreases the motor efficiency. Unlike conventional SRMs, the rotor ...
متن کاملA New Hybrid Brushless DC Motor/Generator without Permanent Magnet
The Brushless DC (BLDC) motor is a simple robust machine which has found application over a wide power and speed of ranges in different shapes and geometry. This paper briefly reviews the fundamentals behind the motor and also the different types of BLDC motors with different geometries and then presents a new configuration for BLDC motor/generator, which does not use a permanent magnet in the ...
متن کاملModelling, simulation and proportional integral control of a pneumatic motor
have shown a considerable amount of interest in the control of pneumatic drives over the past decade, for two main reasons, firstly, the response of the system is very slow and it is difficult to attain set points due to hysteresis and secondly, the dynamic model of the system is highly non-linear, which greatly complicates controller design and development. To address these problems, two strea...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE/ASME Transactions on Mechatronics
سال: 2007
ISSN: 1083-4435,1941-014X
DOI: 10.1109/tmech.2006.886258