A New Power Flow Method in Radial Distribution Systems
نویسندگان
چکیده
منابع مشابه
Fast Decoupled Power Flow for Unbalanced Radial Distribution Systems
This paper presents a novel power flow formulation and an effective solution method for general unbalanced radial distribution systems. Comprehensive models are considered including lines, switches, transformers, shunt capacitors, cogenerators, and several types of loads. A new problem formulation of three-phase distribution power flow equations taking into account the radial structure of the d...
متن کاملPower Flow Analysis for Balanced and Unbalanced Radial Distribution Systems
This paper reports on an efficient method of power flow analysis for solving balanced and unbalanced radial distribution systems. The radial distribution system is modelled as a series of interconnected single feeders. Using Kirchoff’s laws, a set of iterative power flow equations was developed to conduct the power flow studies. Due to the voltage dependency of loads in distribution systems, va...
متن کاملHarmonic Load Flow for Radial Distribution Systems
Radial distribution systems (RDS) require special load flow methods to solve power flow equations owing to their high R/X ratio. Increasing use of power electronic devices and effect of magnetic saturation cause harmonics in RDS. This paper proposes a novel algorithm to compute the power flow solution of a RDS accounting for all the harmonic components. It uses a recursive solution technique. T...
متن کاملfault location in power distribution networks using matching algorithm
چکیده رساله/پایان نامه : تاکنون روشهای متعددی در ارتباط با مکان یابی خطا در شبکه انتقال ارائه شده است. استفاده مستقیم از این روشها در شبکه توزیع به دلایلی همچون وجود انشعابهای متعدد، غیر یکنواختی فیدرها (خطوط کابلی، خطوط هوایی، سطح مقطع متفاوت انشعاب ها و تنه اصلی فیدر)، نامتعادلی (عدم جابجا شدگی خطوط، بارهای تکفاز و سه فاز)، ثابت نبودن بار و اندازه گیری مقادیر ولتاژ و جریان فقط در ابتدای...
A New Method for Considering Distribution Systems in Voltage Stability Studies
In methods presented to calculate the voltage collapse point, the transmission system is usually the only part of the power system that is completely modeled. Distribution systems are often replaced by aggregate load models because the use of the detailed model of distribution systems in voltage stability analysis not only increases the computation time, but also decreases the probability of co...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEJ Transactions on Power and Energy
سال: 2006
ISSN: 0385-4213,1348-8147
DOI: 10.1541/ieejpes.126.290