A new multi-zone model for porosity distribution in Al–Si alloy castings
نویسندگان
چکیده
منابع مشابه
Porosity Prediction in Aluminum A356 Alloy Castings
A comprehensive methodology that takes into account alloy solidification, shrinkage-driven interdendritic fluid flow, hydrogen precipitation, and porosity evolution has been developed for the prediction of microporosity fraction in aluminum A356 alloy castings. The mathematical models presented are implemented in a computational framework consistent with those of commercial casting codes, allow...
متن کاملDevelopment and investigation of three-phase model of the mushy zone for analysis of porosity formation in solidifying castings
-In this paper a three-phase model (liquid, solid and gas) of the mushy zone for investigation of porosity formation in solidifying castings is developed. This model takes into account the release of the dissolved gas from the alloy as well as heat transfer and interdendritic fluid flow in the mushy zone. An important aspect of this work is related to accounting for the term describing porosity...
متن کاملPorosity Control in Copper Rotor Die Castings
This paper reports on the results of an investigation to minimize and control the distribution of porosity in edge-gated copper rotor die castings. A Flow 3-D computer modeling exercise was used to simulate shot profiles that result in formation of large pores in the end rings, as well as to predict improved profiles that will reduce or eliminate the residual porosity. These model results were ...
متن کاملA multi-objective mathematical model for production-distribution scheduling problem
With increasing competition in the business world and the emergence and development of new technologies, many companies have turned to integrated production and distribution for timely production and delivery at the lowest cost of production and distribution and with the least delay in delivery. By increasing human population and the increase in greenhouse gas emissions and industrial waste, in...
متن کاملA New Model for Designing Gas Distribution Networks
A new model for the design of the city gas distribution network has been presented. On the basis of mass flow rates and pressure balances a nonlinear system of equation is obtained. A method for solving the latter is outlined which gives accurate results. Also, this method, when compared to the other accessible ones, takes less computer time. Finally in this method the actual length of netw...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Materialia
سال: 2013
ISSN: 1359-6454
DOI: 10.1016/j.actamat.2013.01.064