منابع مشابه
Magnetic drive system for a new centrifugal rotary blood pump.
The purpose of this investigation was to design a novel magnetic drive and bearing system for a new centrifugal rotary blood pump (CRBP). The drive system consists of two components: (i) permanent magnets within the impeller of the CRBP; and (ii) the driving electromagnets. Orientation of the magnets varies from axial through to 60 degrees included out-lean (conical configuration). Permanent ma...
متن کاملNew photonic-crystal system for integrated optics
We describe a new photonic-crystal structure with a complete three-dimensional photonic band gap (PBG) and its potential application to integrated optics. The structure not only has a large band gap and is amenable to layer-by-layer litho-fabrication, but also introduces the feature of high-symmetry planar layers resembling two-dimensional photonic crystals. This feature enables integrated opti...
متن کاملA new integrated fuzzy bang–bang relay control system
In this paper, we propose a new fuzzy bang–bang relay controller (FBBRC). The bang–bang control systems use switching relays or hard limiter saturation functions with fixed parameters, and their input does not have the flexibility to control the non-linear system over its entire range of operation. The conventional fuzzy bang–bang controllers have an analog output and an external hard limiting ...
متن کاملA New Class of Resonant Discharge Drive Topology for Switched Reluctance Motor
Switched reluctance motor (SRM) drive has a remarkable characteristic, high efficiency, and good controllability, which makes it attractive for high-speed applications. In this paper, the basic control strategy for a switched reluctance motor drive circuit is explained and then three different resonant discharge topologies for SRM drive circuit are proposed. Due to resonantly discharging of exc...
متن کاملDYNAMICAL ANALYSIS AND DESIGN OF FRONT ENGINE ACCESSORY DRIVE SYSTEM
In this paper, Front Engine Accessory Drive (FEAD) system of automotive engine is modeled with ADAMS software. The model is validated using engine test data. It is then used to investigate the effect of design parameters on the system performance such as belt vibration and loads on the idlers. Three alternative layouts were developed in order to improve the performance of original EEAD system. ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Mechanik
سال: 2015
ISSN: 0025-6552
DOI: 10.17814/mechanik.2015.8-9.500