A new flowsheeting tool for flue gas treating
نویسندگان
چکیده
منابع مشابه
Development of New Potassium Carbonate Sorbent for CO2 Capture under Real Flue Gas Conditions
In this paper, the development of a new potassium carbonateon alumina support sorbent prepared by impregnating K2CO3 with an industrial grade of Al2O3 support was investigated. The CO2 capture capacity was measured using real flue gas with 8% CO2 and 12% H2O in a fixed-bed reactor at a temperature of 65 °C using breakthrough curves. The developed sorbent showed an adsorption capacity of 66.2 mg...
متن کاملFlue Gas Conditioning
Flue gas conditioning (FGC) systems offer an effective option for control of Particulate Matter (PM) emissions and enhances the performance of the Electrostatic Precipitators (EPs) when using coal of different properties. The increasing environmental awareness and the mandate of the Environmental Protection Agencies (EPA) in various countries to thermal power stations using coal-fired boilers f...
متن کاملFlue Gas Cooling
When waste heat is not utilized, cooling of flue gases in special cooling chambers becomes necessary, if the dust':'collecting and associated equipment is constructed of metal. The two most common methods of cooling are by dilution with ambient air, and by evaporation of water in the gas stream. Usually, they are combined. Load sharing depends largely on acceptable visibility of stack effluvia ...
متن کاملFlue gas desulfurization
Flue gas desulfurization is commonly known as FGD and is the technology used for removing sulfur dioxide (SO2) from the exhaust combustion flue gases of power plants that burn coal oroil to produce steam for the turbines that drive their electricity generators. The most common types of FGD contact the flue gases with an alkaline sorbent such as lime or limestone. As sulfur dioxide is responsibl...
متن کاملFlue gas treatment for CO2 capture
This report is in two sections: the first describes the flue gas and its treatment in post-combustion capture and the second covers the flue gas in oxyfuel combustion capture. The main components of the flue gas in pulverised coal combustion for postcombustion capture are CO2, N2, O2 and H2O, and air pollutants such as SOx, NOx, particulates, HCl, HF, mercury as well as other contaminants. The ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Energy Procedia
سال: 2009
ISSN: 1876-6102
DOI: 10.1016/j.egypro.2009.01.194