A Multivariate Statistical Quality Control of AISI 52100 Hardened Steel Turning
نویسندگان
چکیده
منابع مشابه
On machining of hardened AISI D2 steel with PCBN tools
This paper describes an experimental investigation on machining of a difficult-to-cut material, AISI D2 steel of hardness 62 HRC with PCBN tools. It was found that the most feasible feeds and speeds fall in the ranges 0.08–0.20 mm/rev and 70–120 m/min, respectively and that most of the tested PCBN tools reached the end of life mainly due to flank wear. The highest acceptable values of tool life...
متن کاملExperimental Study & Modeling of Surface Roughness in Turning of Hardened AISI 4340 Steel Using Coated Carbide Inserted
Turning of hardened steels using a single point cutting tool has replaced the cylindrical grinding now as it offers attractive benefits in terms of lower equipment costs, shorter set up time, fewer process setups, higher material removal rate, better surface quality and elimination of cutting fluids compared to cylindrical grinding. In order to obtain desired surface quality by machining, pr...
متن کاملSurface Roughness, Machining Force and FlankWear in Turning of Hardened AISI 4340 Steel with Coated Carbide Insert: Cutting Parameters Effects
The current experimental study is to investigate the effects of process parameters (cutting speed, feed rate and depth of cut) on performance characteristics (surface roughness, machining force and flank wear) in hard turning of AISI 4340 steel with multilayer CVD (TiN/TiCN/Al2O3) coated carbide insert. Combined effects of cutting parameter (v, f, d) on performance outputs (Ra, Fm and VB) ar...
متن کاملPrediction of Tool Life in End Milling of Hardened Steel AISI D2
Most published research works on the development of tool life model in machining of hardened steels have been mainly concerned with the turning process, whilst the milling process has received little attention due to the complexity of the process. Thus, the aim of present study is to develope a tool life model in end milling of hardened steel AISI D2 using PVD TiAlN coated carbide cutting tool....
متن کاملPreparation and Mechanical Properties of Nano/Ultrafine Bainitic Structure in AISI 52100 Steel
The development of nano/ultrafine bainitic structure in AISI 52100 steel was the goal of this study. For this purpose,the AISI 52100 the specimens were austenitized at 1050 °C for 60 min followed by low-temperature austemperingtreatment at different temperatures and times. The austempered samples were characterized using field emissionscanning electron microscopy (FESEM), X-ra...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Access
سال: 2020
ISSN: 2169-3536
DOI: 10.1109/access.2020.3000585