A Microstructure Obtained on AISI 1018 and AISI M2 Steel by Powder Paste Pack Boriding Process
نویسندگان
چکیده
منابع مشابه
Wear Analysis during End Milling AISI 1018 Steel Using Microlubrication
Microlubrication minimizes the exposure of metal working fluids (MWFs) leading to an economical, safer and healthy workplace environment. In this study vegetable based lubricant is used to conduct wear analysis during end milling AISI 1018 steel using microlubrication. Solid carbide cutting tool was used with varying cutting speed and feed rate having a constant depth of cut. A full factorial e...
متن کاملFeasibility study of friction stir welding of 6061-T6 aluminium alloy with AISI 1018 steel
The present work demonstrates that friction stir welding (FSW) is a feasible route for joining 6061 aluminium (Al) alloy to AISI 1018 steel. The weld has a good weld quality and is free of cracks and porosity. The tensile failure happened at the boundary between the nugget and thermomechanically affected zone of the base Al alloy, indicating that the weld has a higher joining strength. Despite ...
متن کاملMechanical Properties of Boronized AISI 316, AISI 1040, AISI 1045 and AISI 4140 Steels
In this study, some mechanical properties of borided and unborided four steels were investigated. Boronizing of steels was performed by powder pack method at 1210 K for 4 h. The hardness of borides, boride layer thickness and room temperature tensile properties were measured and it was observed that hardness and tensile properties strongly depend on chemical composition of steels. In addition, ...
متن کاملImproving the Microstructure, Mechanical and Magnetic Properties of AISI 4340 Steel Using the Heat Treatment Process
AISI 4340 steel is one of the super strong steels that can be selected for different applications. By designing the proper cycles of heat treatment, the optimum microstructure and properties of this steel can be achieved. In this study, different heat treatment cycles were introduced to achieve the optimum microstructure and improve the mechanical and magnetic properties of AISI 4340 steel. The...
متن کاملHot Forming of Aisi A2 Tool Steel
In order to optimize the hot forming process of tool steels, further improvement of flow stress prediction and additional knowledge on hot deformability, especially at lower and upper limits of the hot working range, are required. The hot working ranges for these steels are very narrow as a consequence of the role of alloying elements, which form carbides. Carbides improve tool steel’s hardenab...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Microscopy and Microanalysis
سال: 2019
ISSN: 1431-9276,1435-8115
DOI: 10.1017/s1431927619012728