A Mechanism of Porosity Distribution in A356 Aluminum Alloy Castings
نویسندگان
چکیده
منابع مشابه
Porosity Prediction in Aluminum A356 Alloy Castings
A comprehensive methodology that takes into account alloy solidification, shrinkage-driven interdendritic fluid flow, hydrogen precipitation, and porosity evolution has been developed for the prediction of microporosity fraction in aluminum A356 alloy castings. The mathematical models presented are implemented in a computational framework consistent with those of commercial casting codes, allow...
متن کاملPorosity Control and Fatigue Behavior in A356-T61 Aluminum Alloy
Much work has been done, in recent years, to characterize the factors that cause porosity in aluminum castings, and to analyze the impact of porosity or microstructural parameters on fatigue life. What has yet to be done is systematically separate out the effects of dendrite arm spacing and largest pore size from each other, and from the underlying chemical and process parameters that influence...
متن کاملSoldering of Aluminum Matrix Composites Sicp/a356 and Kovar Alloy
Article history: Received 28.3.2013 Received in revised form 26.4.2013 Accepted 29.4.2013 Aluminum matrix composites containing 55% SiC particle reinforcing phase/SiC reinforcement phase particle and Kovar alloy 4J29 were chosen as the base metals. After nickel plating on the surface of SiCp/Al, two kinds of materials were soldered together by using Zn-Cd-Ag-Cu as the filler metal and ZnCl2 as ...
متن کاملQuantitative Evaluation of Porosity in Aluminum Die Castings by Fractal Analysis of Perimeter
In the die-casting process, the formation of pores in components is unavoidable. This porosity has a harmful effect on the strength and pressure tightness of die castings. To eliminate the porosity in components, its predominant cause has to be identified as being due to either shrinkage or gas. In practice, however, it is frequently difficult to tell the difference between porosity due to shri...
متن کاملFORMATION OF GLOBULAR STRUCTURES IN ALUMINUM A356 ALLOY BY NARROWMELT STREAM (NMS) TECHNIQUE
Abstract: structures in alloys. This method is based on pouring the melt through a small sized nozzle into a mould located at acertain height under the crucible. This simple method generates globular structures without using equipments such asimpellers, electromagnetic stirrers, ultrasonic probes and cooling slopes. Therefore it is cost effective. In the presentstudy, the effect of casting size...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2002
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.43.1711