A Low-Flicker-Noise 30-GHz Class-F23 Oscillator in 28-nm CMOS Using Implicit Resonance and Explicit Common-Mode Return Path
نویسندگان
چکیده
منابع مشابه
A low phase noise 20 GHz voltage control oscillator using 0.18-μm CMOS technology
A low phase noise, small power dissipation and small sized K-band cascode differential voltage-controlled oscillator (VCO) with capacitive feedback topology using 0.18 μm CMOS technology is described. The VCO operated can be tuned between 19.1 GHz and 20.9 GHz and has low phase noise of -108.67 dBc/Hz at a 1 MHz offset. The output power of the 20.7 GHz is about -21.12 dBm. The Figure of merit (...
متن کاملA 1.8 GHz CMOS Low-Noise Amplifier
A 1.8 GHz low-noise amplifier has been designed and fabricated in a standard 0.35 pm CMOS process. Measurement results indicate that the amplifier has a forward gain (S21) of 10.5 dB and a noise figure of 3.94 dB, while consuming 40 mW from a 2.5 V supply.
متن کاملA W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
متن کاملMillimetre-wave 65nm CMOS Class C Oscillator at 65 GHz
A 65-GHz Class-C LC oscillator designed in 65nm CMOS technology by ST Microelectronics is presented. A three spiral transformer has been used to achieve low phase noise and low power consumption. Post-layout simulations show a phase noise is equal to -88.4 dBc/Hz at 1-MHz offset from the carrier (65.8 GHz). The power consumption is 14 mW with 1.2-V supply voltage. The oscillator is capable to o...
متن کاملA 60-GHz Low Noise Amplifier in 0.13-μm CMOS
The low noise amplifier (LNA) serves as the first component of the radio frequency receiver system. The performance of LNA determines the sensitivity and selectivity of the receiver. In order to maximize performance the gain, noise figure and input matching of LNA needs to be optmized. This paper presents a 60GHz low noise amplifier on 0.13-μm standard CMOS technology designed using classical n...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Journal of Solid-State Circuits
سال: 2018
ISSN: 0018-9200,1558-173X
DOI: 10.1109/jssc.2018.2818681