A Low Capture Power Test Generation Method Based on Capture Safe Test Vector Manipulation
نویسندگان
چکیده
منابع مشابه
Capture-based Automated Test Input Generation
Testing object-oriented software is critical because object-oriented languages have been commonly used in developing modern software systems. Many efficient test input generation techniques for object-oriented software have been proposed; however, stateof-the-art algorithms yield very low code coverage (e.g., less than 50%) on large-scale software. Therefore, one important and yet challenging p...
متن کاملEvaluating Recognition-Based Motion Capture on HumanEva II Test Data
The advent of the HumanEva standardized motion capture data sets has enabled quantitative evaluation of motion capture algorithms on comparable terms. This paper measures the performance of an existing monocular recognition-based pose recovery algorithm on select HumanEva data, including all the HumanEva II clips. The method uses a physically-motivated Markov process to connect adajacent frames...
متن کاملCapture-power-aware test data compression using selective encoding
Ever-increasing test data volume and excessive test power are two of the main concerns of VLSI testing. The ‘‘don’t-care’’ bits (also known as X-bits) in given test cube can be exploited for test data compression and/or test power reduction, and these techniques may contradict to each other because the very same X-bits are likely to be used for different optimization objectives. This paper prop...
متن کاملGeneration of Low Power Test Set by Merging Functional Broadside Test Based Skewed Load Test Cubes
Low power test set is generated by merging of the skewed load test cubes that are extracted from the functional broadside tests. The use of functional broadside tests ensures that switching activity of the extracted tests does not exceed that possible during functional operation of the circuit. As the switching activity is prevented from exceeding the switching activity that the circuit is desi...
متن کاملLayout-aware Low Power Test Pattern Generation
A new test pattern generation method for low power test is presented. The proposed method is based on the scan chain configuration after Place and Route (P&R) process. It is also based on the Weighted Transition Metric(WTM) for low power test pattern generation. It does not need to modify any design process and very easy to run. The experimental results of ISCAS 89’ benchmark circuits show the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEICE Transactions on Information and Systems
سال: 2017
ISSN: 0916-8532,1745-1361
DOI: 10.1587/transinf.2016edp7418