A light heat-resistance alloy based on intermetallic compound TiAl.
نویسندگان
چکیده
منابع مشابه
Boron segregation in a (Fe, V, B) TiAl based alloy
Primary boron containing dispersoids grown from the melt in a Ti-45.5at.%Al-1.6at.%Fel.lat.%V-0.7at.%B alloy, and then annealed at 1473K, have been investigated using optical microscopy, conventional transmission electron microscopy (CTEM) and analytical electron microscopy. The dispersoid morphology is in the form of high aspect ratio plates, hundreds of microns across and cross-sectional widt...
متن کاملAlNb intermetallic alloy
This investigation was conducted to ascertain the benefits of electropolishing after mechanical polishing for electron backscattered diffraction of a Ti 2 AlNb intermetallic Ti − 21Al − 29Nb (at.%) alloy containing the orthorhombic (O) and body-centered-cubic (BCC) phases. Electropolishing was performed at − 40 ° C in 6% H 2 SO 4 methanol solution. Atomic force microscopy was used to measure th...
متن کاملHIGH-TEMPERATURE FRACTURE AND FATIGUE RESISTANCE OF A DUCTILE b-TiNb REINFORCED g-TiAl INTERMETALLIC COMPOSITE
ÐThe high-temperature fatigue-crack propagation and fracture resistance of a model g-TiAl intermetallic composite reinforced with 20 vol.% ductile b-TiNb particles is examined at elevated temperatures of 650 and 8008C and compared with behavior at room temperature. TiNb reinforcements are found to enhance the fracture toughness of g-TiAl, even at high temperatures, from about 12 to 040 MPa m, a...
متن کاملEffect of Welding Heat Input on the Intermetallic Compound Layer and Mechanical Properties in Arc Welding-brazing Dissimilar Joining of Aluminum Alloy to Galvanized Steel
The effect of weld heat input on the formation of intermetallic compound (IMCs) layer during arc welding–brazing of aluminium and steel dissimilar alloys, was investigated through both finite element method (FEM) numerical simulations and experimental measurements. The results of FEM analysis as well as welding experiments indicated that increasing weld heat input increases the thickness of IMC...
متن کاملCharacterizations of Lamellar Interfaces and Segregations in a PST-TiAl Intermetallic Alloy by an Analytical Scanning Transmission Electron Microscope
Polysynthetically-twinned titanium aluminide (PST-TiAl), a fully lamellar γ-TiAl+α2Ti3Al dual-phase alloy, is under evaluation for applications in rotary components in aircraft and automobile industries due to its high specific strength, and a high strength-retention capability at elevated-temperatures. However, the low ductility at roomto mid-high temperatures of the material hinders its appli...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1986
ISSN: 0451-5994
DOI: 10.2464/jilm.36.162