A Hot-Polymer Fiber Fabry–Perot Interferometer Anemometer for Sensing Airflow
نویسندگان
چکیده
منابع مشابه
A Hot-Polymer Fiber Fabry–Perot Interferometer Anemometer for Sensing Airflow
This work proposes the first hot-polymer fiber Fabry-Perot interferometer (HPFFPI) anemometer for sensing airflow. The proposed HPFFPI is based on a single-mode fiber (SMF) endface that is attached to a UV-cured polymer to form an ultracompact fiber Fabry-Perot microcavity. The proposed polymer microcavity was heated using a low-cost chip resistor with a controllable dc driving power to achieve...
متن کاملPhotonic Crystal Fiber Mach-Zehnder Interferometer for Refractive Index Sensing
We report on a refractive index sensor using a photonic crystal fiber (PCF) interferometer which was realized by fusion splicing a short section of PCF (Blaze Photonics, LMA-10) between two standard single mode fibers. The fully collapsed air holes of the PCF at the spice regions allow the coupling of PCF core and cladding modes that makes a Mach-Zehnder interferometer. The transmission spectru...
متن کاملPhotonic crystal fiber tip interferometer for refractive index sensing.
In this paper we present an interferometer based on photonic crystal fiber (PCF) tip ended with a solid silica-sphere for refractive index sensing. The sensor is fabricated by splicing one end of the holey PCF to a single mode fiber (SMF) and applying arc at the other end to form a solid sphere. The sensor has been experimentally tested for refractive index and temperature sensing by monitoring...
متن کاملBackscatter-immune, polarization managed, all fiber Sagnac sensing interferometer.
We propose a new all fiber Mach-Zehnder-Sagnac hybrid interferometer topology for precision sensing. This configuration utilizes a high coherence laser source, mitigates the effects of Rayleigh backscatter and polarization wander, while eliminating scale factor drift. We also present preliminary experimental results, using telecommunications grade single mode fiber and fiber couplers, to demons...
متن کاملTransient thermal response of a hot-wire anemometer
The ability of a thermal anemometry system to accurately measure unsteady fluid velocity depends on the electrical control system as well as the thermal properties of the sensor. The present work is a numerical study of the thermal transient response of a hot-wire. A conventional constant temperature anemometer with an ideal feedback amplifier as well as a pulse width modulated system were used...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Sensors
سال: 2017
ISSN: 1424-8220
DOI: 10.3390/s17092015