A homogeneous model for compressible three-phase flows involving heat and mass transfer.

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Study of MHD Second Grade Flow through a Porous Microchannel under the Dual-Phase-Lag Heat and Mass Transfer Model

A semi-analytical investigation has been carried out to analyze unsteady MHD second-grade flow under the Dual-Phase-Lag (DPL) heat and mass transfer model in a vertical microchannel filled with porous material. Diffusion thermo (Dufour) effects and homogenous chemical reaction are considered as well. The governing partial differential equations are solved by using the Laplace transform method w...

متن کامل

Flow Analysis Heat and Mass Transfer in a Room

This reports the study on the flow behaviour, heat transfer and contamination distribution in a room. For this purpose the 3-D incompressible Navier-Stokes equations, energy equation and a mass transfer equation which model the concentration of contamination have been applied. For turbulence simulation the two equation standard k-  turbulence model was employed. By means of SIMPLE algorithm the...

متن کامل

Two-phase Boundary Layer Flow, Heat and Mass Transfer of a Dusty Liquid past a Stretching Sheet with Thermal ‎Radiation

‎The problem of two-phase MHD boundary layer flow, heat and mass transfer over a stretching sheet with fluid-particle suspension and thermal radiation has been studied. The effect of mass transfer in dusty fluid over a stretching sheet is considered for the first time. The governing equations are reduced to a set of non-linear ordinary differential equations under suitable similarity transforma...

متن کامل

comparison of mass transfer models and proper model selection in anticipation of cavitation for internal flows

influences of three prevalent mass transfer models, on modeling of cavitation, are investigated numerically. two models of singal and zwart are implemented in an open source code, open foam, while the kunz model is available for cavitation modeling. each model is used to flow simulation through a venturi. volume of gas fraction, in the specified sections of conduit, is compared to experimental ...

متن کامل

Parallel simulation of three-dimensional complex flows: Application to two-phase compressible flows and turbulent wakes

In this paper, we present parallel simulations of three-dimensional complex flows obtained on an ORIGIN 3800 computer and on homogeneous and heterogeneous (processors of different speeds and RAM) computational grids. The solver under consideration, which is representative of modern numerics used in industrial computational fluid dynamics (CFD) software, is based on a mixed element-volume method...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: ESAIM: Proceedings and Surveys

سال: 2019

ISSN: 2267-3059

DOI: 10.1051/proc/201966005