A High Power Quality Buck-H Auxiliary Power Converter in Railway Applications
نویسندگان
چکیده
DC voltage utilization and AC harmonics are important evaluation indexes for Auxiliary Power Converter in Railway Applications. To improve the above two indicators, a novel switch-mode modulation method quasi-PR control strategy Buck-H three-phase inverter is proposed this paper. The integrates side filter circuit into Buck circuit, which reduces volume of capacitor improves filtering effect. This uses only one high frequency switch per phase, switching losses thereby increases overall efficiency. In addition, absence shoot-through menace eliminates dead time requirement. Meanwhile, quasi-proportional-resonance (PR) controller its parameters optimized to tracking performance. influence PR on system performance analyzed detail. can effectively reduce harmonic distortion rate system. effectiveness verified through StarSim hardware-in-the-loop experimental results.
منابع مشابه
emittance control in high power linacs
چکیده این پایان نامه به بررسی اثر سیم پیچ مغناطیسی و کاوه یِ خوشه گر با بسامد رادیویی بر هاله و بیرونگراییِ باریکه هایِ پیوسته و خوشه ایِ ذرات باردار در شتابدهنده های خطیِ یونی، پروتونی با جریان بالا می پردازد و راه حل هایی برای بهینه نگهداشتن این کمیتها ارایه می دهد. بیرونگرایی یکی از کمیتهای اساسی باریکه هایِ ذرات باردار در شتابدهنده ها است که تاثیر قابل توجهی بر قیمت، هزینه و کاراییِ هر شتابدهند...
Passivity-Based Control of the DC-DC Buck Converters in High-Power Applications
In this paper, a novel approach for control of the DC-DC buck converter in high-power and low-voltage applications is proposed. Designed method is developed according to passivity based controller which is able to stabilize output voltage in a wide range of operation. It is clear that in high-power applications, parasitic elements of the converter may become comparable with load value and hence...
متن کاملDesign of a High frequency Hysteresis-Controlled CMOS Buck Converter for low power Applications
This paper presents the design of a 20 MHzhysteresis-controlled CMOS buck converter using pseudo ramp techniques for ultra-low power applications. The proposed buck converter can improve the transient response using hysteresis-controlled and fixed-voltage band techniques. Using pseudo ramp technique, pseudo inductor current signal can be produced to reduce the output voltage ripple. At the same...
متن کاملA. a Novel Two-quadrant Soft-switching Converter with One Auxiliary Switch for High Power Applications
There has been an increasing interest in the soft-switching power conversion technologies in order to overcome the limitations of the hard-switching technologies [1]-[7]. Soft-switching (SS) converters had many advantages over hard-switching (HS) converters. For example, SS converters lower switching losses, reduce voltage/current stress, reduce EMI, and allow a greater high switching frequency...
متن کاملPower Quality Improvement in a PMBLDCM Drive Using a forward Buck Converter
Solid-state switch-mode rectification converters have reached a matured level for improving power quality in terms of power-factor correction (PFC), reduced total harmonic distortion at input ac mains and precisely regulated dc output in buck, boost, buck–boost and multilevel modes with unidirectional and bidirectional power flow. In this paper, an improved power quality converter employing con...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Frontiers in Energy Research
سال: 2022
ISSN: ['2296-598X']
DOI: https://doi.org/10.3389/fenrg.2022.926707