A high-efficiency active clamped flyback AC-DC converter using an integrated digital isolator in isolated communication

نویسندگان

چکیده

This paper presents a 45w (20V, 2.25A) output active clamped flyback (ACF) AC-DC controller using capacitor-coupled integrated digital isolator in isolated communication place of bulky optocoupler, which not only helps to reduce system volume but also improves the reliability ACF converter. In contrast with conventional ACF, this features delicate adaptive zero voltage switching (ZVS) control conduction and losses so as improve power efficiency. Designed 0.18-μm BCD process, simulation result shows proposed converter approached 95.1% maximum efficiency when GaN transistors are used switches. The feasibility is verified exhibits high transmission accuracy low propagation delay.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

High-Efficiency Isolated Bidirectional Ac–Dc Converter for a Dc Distribution System

The isolated bidirectional ac–dc converter is for the 380-V dc power distribution system to control the bidirectional power flow and to improve its power conversion efficiency. Here the high-side switches of the ac– dc rectifier employ IGBTs without anti-parallel diodes and SiC diodes. In addition, the low-side switches are consisting of two MOSFETs to reduce the conduction loss in the rectific...

متن کامل

A New Single-Phase Single-Stage AC-DC Stacked Flyback Converter With Active Clamp ZVS

Single-stage AC-DC converters integrate an AC-DC front-end converter with a DC-DC backend converter. Compared with conventional two-stage AC-DC converters, single-stage ACDC converters use less components and only one controller, which is used to regulate the output voltage. As a result, the cost, size and complexity of AC-DC converters can be reduced, but single-stage converters do not perform...

متن کامل

High Frequency Integrated DC/DC Converter Digital Control

This work focuses on the power management of electronic circuits that operate with low load currents, in the range of a few hundred mA, with voltage regulated by a DC/DC converter since efficiency requirements don’t allow to consider the application of a linear regulator. Therefore, the use of a buck converter, whose efficiency doesn’t decrease significantly with the decrease of the load curren...

متن کامل

Comparison of an Isolated bidirectional Dc-Dc converter with and without a Flyback Snubber

Renewable energy sources like solar and fuel cells are emerging as a promising supplementary power sources due to their merits of cleanness, high efficiency, and high reliability. But the output levels of these are low. An isolated bidirectional full-bridge dc–dc converter can be used for interfacing battery to the system. Because of the presence of leakage inductance of the isolation transform...

متن کامل

A Developed Structure of Step-Up DC/DC Converter by Using Coupled Inductor and Active Clamped Circuit

In this paper, a new structure of step-up dc-dc converter by using coupled inductor and active-clamped circuit is proposed. The proposed converter generates high voltage gain in comparison with the conventional dc-dc converters. Duo to using active-clamped circuit in the proposed topology the voltage stress on main switch is reduced. In addition the zero voltage switching (ZVS) in ON-state of m...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: IEICE Electronics Express

سال: 2023

ISSN: ['1349-2543', '1349-9467']

DOI: https://doi.org/10.1587/elex.20.20230318