A Gear Cutting Predictive Model Using the Finite Element Method
نویسندگان
چکیده
منابع مشابه
buckling of viscoelastic composite plates using the finite strip method
در سال های اخیر، تقاضای استفاده از تئوری خطی ویسکوالاستیسیته بیشتر شده است. با افزایش استفاده از کامپوزیت های پیشرفته در صنایع هوایی و همچنین استفاده روزافزون از مواد پلیمری، اهمیت روش های دقیق طراحی و تحلیل چنین ساختارهایی بیشتر شده است. این مواد جدید از خودشان رفتارهای مکانیکی ارائه می دهند که با تئوری های الاستیسیته و ویسکوزیته، نمی توان آن ها را توصیف کرد. این مواد، خواص ویسکوالاستیک دارند....
Evaluation of Disc Cutter Performance in Rock Cutting Process Using 3D Finite Element Method
Today, numerical simulation can be used as a suitable tool to measure large quantities that are very expensive and, in some cases, impossible to measure. One of the important issues in predicting rock mass boreability in excavation with full face tunnel boring machines is estimating the discchr('39')s forces for rock cutting. For this purpose, the linear cutting test is employed. However, limi...
متن کاملSimulation of Surgical Cutting Using a Progressive Cutting Scheme and Extended Finite Element Method
Accuracy and speed are two of the most important problems in the real-time Finite Element Method (FEM)-based simulations of surgical cutting [1][2]. While the latter can be gradually eased through GPU-based acceleration[3][4], the former hasn't been properly addressed even until recently. To enable realistic and accurate simulation, the cutting line should follow the exact movement of the user-...
متن کاملAnalysis of a gear train using finite element modelling
Here the theoretical maximum contact stress is calculated by Hertz equation. Also the finite element analysis of spur gear is done to determine the maximum contact stress by ANSYS 14.5. It was found that the results from both Hertz equation and Finite Element Analysis are comparable. From the deformation pattern of steel and grey cast iron, it could be concluded that difference between the maxi...
متن کاملDevelopment of a Predictive Finite Element Model For Investigation of Phases Behavior After Cold Rolling Process
One of the surface defects that arise in sheet metal working is when the part removes from the die. Since there are no external forces to make this defect, the origin of such fail is known as residual stress. Residual stress can develop in sheet metal forming due to non uniform deformation. In this paper, the workpiece is carbon steel with different volume fractions and arrangement of ferrite ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia CIRP
سال: 2013
ISSN: 2212-8271
DOI: 10.1016/j.procir.2013.06.064