A Finishing Method for Higher Roundness of Cylinder
نویسندگان
چکیده
منابع مشابه
Development of a novel method in TRMC for a Binary Gas Flow Inside a Rotating Cylinder
A new approach to calculate the axially symmetric binary gas flow is proposed Dalton’s law for partial pressures contributed by each species of a binary gas mixture (argon and helium) is incorporated into numerical simulation of rarefied axially symmetric flow inside a rotating cylinder using the time relaxed Monte-Carlo (TRMC) scheme and the direct simulation Monte-Carlo (DSMC) method. The res...
متن کاملResidual Stresses Measurement of a Quenched Cylinder using Slitting Method
Residual Stress measurement has gained interests among researchers for many years due to its great influence on the structural integrity. Slitting method is one of the destructive techniques that relies on the introduction of an increasing cut to a part containing residual stresses. Similar to all other mechanical strain relief techniques, slitting also suffers from its shortcomings during the ...
متن کاملAn Experimental Study of Compound Control Method around a Cylinder
In this work, the compound flow control method (passive and active) has been described. EHD actuators as wire-plate (active) and splitter plate (passive) were coupled and applied to control fluid flow and heat transfer around cylinder in cross flow. Investigation consists of the interaction between electric field, fluid flow and temperature field. Experimental tests included various positions o...
متن کاملA New Method for Estimation of Creep of Concrete Using Short-TermTests under Higher Temperature
In the Present study, attempt will be made to propose a new method for prediction of long-term essential creep of concrete utilizing some short-term creep tests under high temperature. To do so, regarding the similarities between essential creep of concrete and creep in viscoelastic materials, the time–temperature equivalence relation in viscoelastic materials is evaluated for concrete. This re...
متن کاملA New Method for Estimation of Creep of Concrete Using Short-TermTests under Higher Temperature
In the Present study, attempt will be made to propose a new method for prediction of long-term essential creep of concrete utilizing some short-term creep tests under high temperature. To do so, regarding the similarities between essential creep of concrete and creep in viscoelastic materials, the time–temperature equivalence relation in viscoelastic materials is evaluated for concrete. This re...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Precision Engineering
سال: 1977
ISSN: 0374-3543
DOI: 10.2493/jjspe1933.43.1167