A Fault Line Selection Method for Distribution System Based on Distribution Automation Data
نویسندگان
چکیده
منابع مشابه
modeling loss data by phase-type distribution
بیمه گران همیشه بابت خسارات بیمه نامه های تحت پوشش خود نگران بوده و روش هایی را جستجو می کنند که بتوانند داده های خسارات گذشته را با هدف اتخاذ یک تصمیم بهینه مدل بندی نمایند. در این پژوهش توزیع های فیزتایپ در مدل بندی داده های خسارات معرفی شده که شامل استنباط آماری مربوطه و استفاده از الگوریتم em در برآورد پارامترهای توزیع است. در پایان امکان استفاده از این توزیع در مدل بندی داده های گروه بندی ...
fault location in power distribution networks using matching algorithm
چکیده رساله/پایان نامه : تاکنون روشهای متعددی در ارتباط با مکان یابی خطا در شبکه انتقال ارائه شده است. استفاده مستقیم از این روشها در شبکه توزیع به دلایلی همچون وجود انشعابهای متعدد، غیر یکنواختی فیدرها (خطوط کابلی، خطوط هوایی، سطح مقطع متفاوت انشعاب ها و تنه اصلی فیدر)، نامتعادلی (عدم جابجا شدگی خطوط، بارهای تکفاز و سه فاز)، ثابت نبودن بار و اندازه گیری مقادیر ولتاژ و جریان فقط در ابتدای...
A Method of Fault Line Detection in ’ Distribution Systems Based on Wavelets
On the basis of farther research about characteristics of single-phase-to-ground fault transient information in neutral indirectly grounded systems and feature information which is abstracted from transient fault signals by wavelet, a novel fault line identifying method using signal singularity detection with the wavelet transform modulus maxims is presented in this paper. A new criterion is co...
متن کاملIntelligent Automation System for Electrical Energy Distribution
In this paper, the functions that can be automated in distribution systems can be classified into two categories, namely, monitoring functions and control functions. Monitoring functions are those needed to record meter readings at different locations in the system, the system status at different locations and events of abnormal conditions. The data monitored at the system level are not only us...
متن کاملCustomized Fault Management System for Low Voltage (LV) Distribution Automation System
Supply disruption such as overloading will cause interruptions of electricity supply to customers. The technicians have to manually locate the fault point and this tedious work may last for extended periods of time. The other reasons are the lack of use of efficient tools for operational planning and advanced methodology for quick detection of fault, isolation of the faulty section and service ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: DEStech Transactions on Engineering and Technology Research
سال: 2018
ISSN: 2475-885X
DOI: 10.12783/dtetr/apop2017/18728