A FASTBUS flash ADC system for the mark II vertex chamber
نویسندگان
چکیده
منابع مشابه
New Drift Chamber for - the Mark Ii
A new cylindrical drift chamber is being constructed for the Mark lI detector for use at the new SLAC Linear Collider. The design of the new chamber is based on a multi-sensewire cell of the jet-chamber type. In addition to driitime measure men@ pulse height measurements from the sense wires will provide electron-hadron separation by dE/dz. The design and construction of the chamber, tests of p...
متن کاملLow Power Flash ADC
In this paper, a new design for a low power CMOS flash Analog-to-Digital Converter (ADC) is proposed. A 6-bit flash ADC, with a maximum acquisition speed of 1GHz, is implemented in a 1.2 V analog supply voltage. HSpice simulation results for the proposed flash ADC verifying the analytical results are also given. It shows that the proposed 6-bit flash ADC consumes less power i n a commercial 90n...
متن کاملThe Mark Ii Vertex Detectors: Status and Prospects*
The art of detecting heavy quark and lepton decay vertices among the collision products of e+einteractions has developed rapidly in the past ten years. To date, there have been three generations of detectors employed or under construction for measuring and identifying heavy quark and lepton decays. Figure 1 plots the history of the field since the beginning of the PEP/PETRA era in terms of the ...
متن کاملDesign of CMOS Comparators for FLASH ADC
The analog to digital converters is the key components in modern electronic systems. As the digital signal processing industry grows the ADC design becomes more and more challenging for researchers. In these days an ADC becomes a part of the system on chip instead of standalone circuit for data converters. This increases the requirements on ADC design concerning for example speed, power, area, ...
متن کاملA Preamp-ADC Interface Amplifier For The BaBar Drift Chamber
The amplifier described in this note is intended to interface an existing preamplifier chip under development by D. Dorfan and N. Spencer at UCSC with a conventional ADC module. The preamp chip provides differential-voltage-mode outputs capable of driving 50-Ω loads. However, the differential channels are made up of emitter-followers with approximately 4Vbe of voltage difference under zero sign...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Nuclear Science
سال: 1989
ISSN: 0018-9499,1558-1578
DOI: 10.1109/23.34517