A Experimental Formulae on Pressure of Small Cyclone Dust Separator

Investigation of Separator Cyclone Performance Using CFD Simulation: A Case Study of Cement Industry Cyclone

This paper tends to investigate the performance of a separator cyclone used in cement industries in Iran. This investigation was performed using CFD modeling, which is validated by other valid studies. Separator cyclone performance includes of two important parameters as pressure drop and collection ratio. In this presented study, the pressure drop has been considered to assess the performance ...

Numerical Study of Gas-solid Flow in a Cyclone Separator

This paper presents a numerical study of the gas-powder flow in a typical Lapple cyclone. The gas flow is obtained by the use of the Reynolds stress model. The resulting pressure and flow fields are verified by comparison with the measured results and then used in the determination of powder flow that is simulated by the use of a Stochastic Lagrangian model. The separation efficiency and trajec...

Experimental Investigation on the Effect of Parameters Influencing the Performance of a Horizontal Styrene-Water Separator

Simulation and Optimization of Cyclone Dust Separators

Cyclone Dust Separators are devices often used to filter solid particles from flue gas. Such cyclones are supposed to filter as much solid particles from the carrying gas as possible. At the same time, they should only introduce a minimal pressure loss to the system. Hence, collection efficiency has to be maximized and pressure loss minimized. Both the collection efficiency and pressure loss ar...

Application of Response Surface Methodology for Modeling and Optimization of the Cyclone Separator for Minimum Pressure Drop

A Response surface design of experiment has been performed based on the Muschelknautz method of modeling (MM) for 64 test cases using Box-Behnken design to study the effect of seven geometrical cyclone dimensions on the pressure drop and cut-off diameter. It is found that the most significant geometrical parameters are, the vortex finder diameter, the inlet section width and height, and the cyc...