A detailed study of mode II test specimen with elastic or plastic crack tips by using boundary element method
نویسندگان
چکیده
In linear elastic fracture mechanics the stress and strain magnification at crack tip is characterized by intensity factors which have been obtained for a large variety of loading specimen geometries course mode II test included. this paper not only different kinds boundary conditions contact surfaces will be discussed but plastic one. The rotation center line also discussed. results show powerful application BEM model in specimen.
منابع مشابه
Study of cavities in a creep crack growth test specimen
During their operation, modern aircraft engine components are subjected to increasingly demanding operating conditions, especially the high pressure turbine (HPT) blades. Such conditions cause these parts to undergo different types of time-dependent degradation, one of which is creep. A model using the finite element method (FEM) was developed, in order to be able to predict the creep behaviour...
متن کاملNumerical modelling of elastic-plastic deformation at crack tips in composite material under stress wave loading
The paper deals with the elastic-plastic wave propagations in an anisotropic material subjected to impact loading with emphasis on an ideal fibre-reinforced cubic material under two-dimensional plane strain condition. The system of partial differential equations is hyperbolic. Therefore a characteristic-based difference method is proposed to calculate the formation of the plastic zone at the cr...
متن کاملThe Elastic-plastic Mechanics of Crack Extension
This paper briefly reviews progres~ in the elastic plastic analysis of crack extension. Analytical results for plane strain and plane stress deformation fields are noted, and elastic-plastic fracture instability as well as transitional behavior and combined rate and thermal effects are discussed.
متن کاملFinite Element Modeling of Crack Initiation Angle Under Mixed Mode (I/II) Fracture
Present study deals with the prediction of crack initiation angle for mixed mode (I/II) fracture using finite element techniques and J-Integral based approach. The FE code ANSYS is used to estimate the stress intensity factor numerically. The estimated values of SIF were incorporated into six different crack initiation angle criteria to predict the crack initiation angle. Single edge crack spec...
متن کاملElastic-plastic Mode-ii Fracture of Adhesive Joints
A numerical study of the elastic-plastic mode-II fracture of adhesive joints is presented in this paper. A traction-separation law was used to simulate the mode-II interfacial fracture of adhesively-bonded end-notched flexure (E.N.F.) specimens loaded in three-point bending, with extensive plastic deformation accompanying failure. The fracture parameters for the traction-separation law were det...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of physics
سال: 2021
ISSN: ['0022-3700', '1747-3721', '0368-3508', '1747-3713']
DOI: https://doi.org/10.1088/1742-6596/1978/1/012019