A comprehensive model for uniform heat flux inside cavity receiver with air-carbon mixture
نویسندگان
چکیده
منابع مشابه
Three-dimensional Flux Prediction for a Dish Concentrator Cavity Receiver
2 BEng(Hons), PhD student, RSE, ANU. 3 BEng, Occupational Trainee, RSE, ANU. 4 Professor, School of Mathematical and Geospatial Sciences, RMIT University, GPO Box 2476 Melbourne 3001, Australia 5 BE(Hons)/BSc, PhD, Lecturer, RSE, ANU. 6 BSc (Eng), MSc (Eng), Engineer. Abstract This paper describes the development of ray tracing models for a 500 m dish concentrator. Two distinct types of model h...
متن کاملAn Air-Based Cavity-Receiver for Solar Trough Concentrators
A cylindrical cavity-receiver containing a tubular absorber that uses air as the heat transfer fluid is proposed for a novel solar trough concentrator design. A numerical heat transfer model is developed to determine the receiver’s absorption efficiency and pumping power requirement. The 2D steady-state energy conservation equation coupling radiation, convection and conduction heat transfer is ...
متن کاملInvestigation of heat loss from a solar cavity receiver
This study examines experimentally the heat loss from a model solar cavity receiver. For this purpose, laboratory-scale cylindrical cavity models with geometric aspect ratios (cavity length to diameter) of 1 and 2, and aperture opening ratios (aperture diameter to cavity diameter) of 0.5 and 1, were built. Each cavity was subjected to constant boundary heat input via heating cables, and was ope...
متن کاملCuO/water Nanofluid Convective Heat Transfer Through Square Duct Under Uniform Heat Flux
Sometimes the need for non-circular ducts arises in many heat transfer applications because of lower pressure drop of non-circular cross section such as square duct compared to circular tube, particularly in compact heat. But square cross section has poor heat transfer performance and it is expected that using a nanofluid as a new heat transfer media may improve the heat transfer performance of...
متن کاملA simple Analytical model for solidification cooling rate based on the local heat flux density
A new simple analytical model for prediction of cooling rate in the solidification process based on the local heat flux density extracted during solidification is introduced. In the modeling procedure, a solidifying control volume is considered in the mushy zone in which a heat balance equation is used to derive the present model. As the local heat flux density is a measurable parameter, the pr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Energy Procedia
سال: 2017
ISSN: 1876-6102
DOI: 10.1016/j.egypro.2017.12.029