A compact model of MOSFET mismatch for circuit design
نویسندگان
چکیده
منابع مشابه
investigating the feasibility of a proposed model for geometric design of deployable arch structures
deployable scissor type structures are composed of the so-called scissor-like elements (sles), which are connected to each other at an intermediate point through a pivotal connection and allow them to be folded into a compact bundle for storage or transport. several sles are connected to each other in order to form units with regular polygonal plan views. the sides and radii of the polygons are...
Understanding MOSFET Mismatch for Analog Design
Despite the significance of matched devices in analog circuit design, mismatch modeling for design application has been lacking. This paper addresses misconceptions about MOSFET mismatch for analog design. t mismatch does not follow a simplistic 1 ( area) law, especially for wide/short and narrow/long devices, which are common geometries in analog circuits. Further, t and gain factor are not ap...
متن کاملThe Advanced Compact MOSFET Model and its Application to Inversion Coefficient Based Circuit Design
Contemporary MOSFET mathematical models contain many parameters, most of which have little or no meaning to circuit designers. Designers therefore, continue to use obsolete models -such as the MOSFET square law -for circuit design calculations. However, low-voltage, lowpower systems development demands more advanced circuit design techniques. In this paper I present a brief literature review of...
متن کاملA Simple MOSFET Model for Circuit Analysis
A simple, general, yet realistic MOSFET model, namely the nth power law MOSFET model, is introduced. The model can express I -V characteristics of short-channel MOSFET's at least down to 0.25-pm channel length and resistance inserted MOSFET's. The model evaluation time is about 1 / 3 of the evaluation time of the SPICE3 MOS LEVEL3 model. The model parameter extraction is done by solving single ...
متن کاملMosfet Modeling for Rf Circuit Design
In this paper, we discuss some important issues in MOSFET modeling for radio-frequency (RF) integratedcircuit (IC) design. We start with the introduction of the basics of RF modeling. A simple sub-circuit model is presented with comparisons of the data for both y parameter and fT characteristics. Good model accuracy is achieved against the measurements for a 0.25μm RF CMOS technology. The high ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Journal of Solid-State Circuits
سال: 2005
ISSN: 0018-9200
DOI: 10.1109/jssc.2005.852045