A Capacitively Degenerated 100-dB Linear 20–150 MS/s Dynamic Amplifier
نویسندگان
چکیده
منابع مشابه
A 2 GHz CMOS dB-Linear Amplifier with 51 dB D
A 2 GHz programmable-gain amplifier (PGA) using 0.12-μm CMOS technology is presented in this paper, which has a 51 dB gain control range with 3 dB gain control steps. The maximum output power of this PGA achieves 9 dBm while the 1-dB compression point is located at 8 dBm. A high linearity denoted by the oIP3 of 22 dBm at the maximum gain has been achieved. A new configuration to digitally imple...
متن کاملAn Inherently dB-linear All-CMOS Variable Gain Amplifier
This paper introduces a simple variable gain amplifier (VGA) structure that shows an inherently dB-linear gain control property. Requiring no additional components for dB-linear control, the structure is compact and power efficient. The designed two-stage VGA shows a gain control range of 60dB with the gain error in the range of ±0.4 dB. The power consumption including the output buffer is 20.4...
متن کاملA 100 A, 100 kHz Transconductance Amplifier
A high-current, wide-band transconductance amplifier is described that provides an unprecedented level of output current at high frequencies with exceptional stability. It is capable of converting a signal voltage applied to its input into a groundreferenced output rms current up to 100 A over a frequency range from dc to 100 kHz with a useable frequency extending to 1 MHz. The amplifier has a ...
متن کاملTransformer-Feedback Degenerated Low-Noise Amplifier
Owing to its well-known properties of possible power-noise match as well as superior noise performance, the inductively-degenerated low-noise amplifier is nowadays the most-widely used RF pre-amplifier topology. However, there is not much flexibility when setting the amplifier’s input impedance to match the source impedance, as for a given biasing condition, matching is achievable only for a pa...
متن کاملA 1.8V and 2GHz Inductively Degenerated CMOS Low Noise Amplifier
This paper presents the design and simulation of Low Noise Amplifier (LNA) in a 0.18μm CMOS technology. The LNA function is to amplify extremely low noise amplifier without adding noise and preserving required signal to noise ratio. Cadence design tool Spectre_RF is used to design and simulation based on resistors, inductors, capacitors and transistors. Power constrained methodology is used for...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Journal of Solid-State Circuits
سال: 2018
ISSN: 0018-9200,1558-173X
DOI: 10.1109/jssc.2017.2778277